Cam sensor on a 2006 Dodge Cummins is found just below the fuel injection pump. It is attached to back of the timing gear housing. It is attached with an Allen head bolt.
A 1989 5.9L Cummins does not have a cam sensor.
a 1993 doesn't have a cam sensor. the crankshaft position sensor is located on the front of the engine directly above the crankshaft pulley
i been searching for it on my 2004 and cant find it either.
A 2002 Dodge does have a cam sensor, but the 318 was not offered after 2001.
Lower/front/driver side of the block. The one aiming at the crank pulley is the crank sensor. The cam sensor is just above it.Lower/front/driver side of the block. The one aiming at the crank pulley is the crank sensor. The cam sensor is just above it.
The 2006 Dodge Charger has single overhead cam (SOHC).
The 2006 Dodge Durango has single overhead cam (SOHC).
2006 was the last Neon. The cam sensor was located on the driver side end of the cylinder head.
The cam sensor is under the front of the passenger side cylinder head.
A 2001 Ram did not have a 3.7L. A 2001 3.7L does not interchange with a 2006, the cam and crank sensor tone rings are different.
The cam sensor on a Dodge 4.7L is under the front outside of the passenger side cylinder head.
There is no such thing as a cam sensor valve. The camshaft position sensor is powered by the PCM, there is no individual fuse.