Should be under the distributor cap
Under the front of the right cylinder head. If you look up from underneath you can see the three wire connecter. ************please note that this answer is wrong...this is the location of the CRANK SHAFT SENSOR****************
The cam sensor is the "pick up" plate in the distributor. That is the black plate under the rotor.
A 2002 Dodge does have a cam sensor, but the 318 was not offered after 2001.
Yes
The cam sensor is inside the distributor and tells the computer the rotational location of the camshaft.
A 1989 5.9L Cummins does not have a cam sensor.
position cam sensor 3.9 licon ls
what is location of cam positioning sensor on 2005 scion xb
IS this a 5.2, if so the crank sensor is on the passenger side of the engine, in the far rear, it picks up off the flywheel, the cam sensor is located inside the distributor (it is the pick up coil).
The cam sensor is in the distributor.
Cam sensor on 1996 Dodge intrepid 3.5 V6 is on the driver's side on top where the cam gear turns on the front of the engine.. Usually has a 90 deg. connector for the wires.. MUST be air gapped correctly to work proplerly.. DO NOT Bottom the sensor out against the cam gear unless the new sensor has a card board disc glued to the end of the sensor to set the gap... Good luck!
It is under the front of the passenger side cylinder head.