Where is the fuel pump located on a 1991 Chevy Lumina?
Fuel Pump Location In the fuel tank. There are numerous ways of getting to the pump. A mechanic, or if you cant afford one, like I couldn't, you either drop the tank, nearly impossible, or you take out the back seats, move carpet and insulation, and "cut" a hole in the body to get to it. I have removed lots of tanks to do this for in the past 15 yrs or so, and found this last option a great one, as on the lumina's, without a proper tool, you have to drop the rear axle assembly, pain in the buttux.
90 people found this useful
Answer . \nBEHIND RIGHT HEADLIGHT STARTING CLOSEST TO RADIATOR SHOULD BE 3RD ONE OVER 3.1 V-6 ENG
Fuel fuse and relay location . \nThere is a black box about 3" on a side on the driver-side shock mount tower, it should have a positive terminal near it. The top of the b…ox will say something like Fuel relay, when you remove it, it has a relay and the fuel pump fuse. You can remove the fuse and run the engine dry to de-pressurize the fuel rails so you can change the fuel filter back by the gas tank. Good Luck
Located inside the fuel tank. Answer It all depends on what year the car is: could be internal ( gas tank ) or external. Mine is a 1996 and it is external.
you must disconnect the negative batery cable. then releive the fuel pressure. then you must take the gas tank off because the fuel pump is on the top of the gas tank. you wil…l need a lift it is about a 3 hour joboh yeah and you have to siphon the gas out of the tank only you cant do that until you take the tank off (hence the need for a lift)good luck
I'm about 99% sure that it is in the gas tank. Yes, you do have to drop the tank to replace this. Answer Make that 100%. Mark Answer Baloney!!! I changed mine. It is… accesable under the back seat. Answer Both you guys are right - you can change it either by removing the gas tank or by taking off the back seat, but it'll take the same amount of time either way.
\n. \n Answer \n. \n. \nI don't believe there is one on GM products. GM has had many fuel pump problems though. Mark\n. \n Answer \n. \nYour correct Mark, there i…sn't one.
Answer . \nMounted on top of the tank.
Answer . \nI have a 93 Chevy Beretta and mine is located INSIDE my fuel tank so I would look there.. Answer . \nin the fuel tank
Answer . goto your parts store and pick up a manaul for about $20.00. Yea, well apparently that wasn't helpful. . So here's what RTFM says (quick tip, read all the instr…uctions to figure out what parts you're going to need. RTFM doesn't list them.): . 1. Loosen or remove the gas cap to relieve the pressure in the tank, and leave it loosened or off.. 2. Put the vehicle on jack stands or other suitable/safe supports.. 3. Under the vehicle, detach the fuel pump electrical connector. It should be the only connector coming from the fuel tank.. 4. Carefully lower the vehicle.. 5. Start the engine and run until it stalls, then crank the starter for another 3 seconds to make sure the pressure is out.. 6. Raise the car again, and reattach the fuel pump electrical connector.. 7. Retighten the gas cap.. 8. Disconnect the negative battery cable (may be necessary to lower the car; if so, jack it back up afterwards).. CAUTION: Observe all applicable safety precautions when working around gasoline. Do not allow fuel spray or fuel vapors to come in contact with a spark or open flame. Keep a Class B dry chemical fire extinguisher near the work area. Never drain or store fuel in an open container due to the possibility of fire or explosion. . 9. Thoroughly clean around all hose connections, and, using a suitable hand-operated pump, drain the fuel through the filler tube into an approved container.. 10. Detach the quick-connects from the fuel sender assembly and remove the fuel lines. 11. Using tool J35731 (Google search or call an autoparts store, they'll find it), or an equivalent spanner wrench, remove the fuel sender lockring. 12. Lift the sender assembly out of the fuel tank. 13. Remove the sender O-ring from the top of the sender and discard. WARNING: Do NOT run the fuel pump UNLESS it is submerged in fuel. Running it dry will cause serious damage to the fuel pump and may cause the pump to EXPLODE due to the oxygen in the air. USE EXTREME CAUTION! 14. Note the position of the fuel pump strainer on the fuel pump and, while supporting the pump assembly in one hand, twist the strainer off the pump and discard the strainer. 15. Detach the fuel pump electrical connector. 16. Remove the clamp from the fuel line at the top of the pump. 17. Hold the fuel sender upside down on a work bench and pull the fuel pump out of the lower mounting bracket. Once the pump is clear of the lower mounting bracket, tilt the pump outward and disconnect the pump from the sender assembly. INSTALLATION: 18. Replace any attaching hoses or rubber sound insulators that show signs of deterioration. 19. Installt the rubber bumper and insulator on the fuel pump. 20. Hold the fuel sender upside down and install the fuel pump between the fuel pulse dampener and mounting bracket. 21. Attach the fuel pump electical connector 22. Install the retaining clamp on the fuel line 23. Install a new fuel pump strainer on the outer edge of the ferrule until fully seater. The strainer must be facing the same direction as it was before removal. 24. Position a new O-ring on the top of the fuel tank and install the sender assembly. 25. Install the lockring using the spanner wrench. 26. Reinstall the fuel tank. 27. Refill gas tank. 28. Connect the negative battery cable. . 29. Say a little prayer, turn the ignition switch to the ON position (don't crank yet) to pressurize the fuel system and check for leaks.. 30. Start car, and if everything is in proper working order, enjoy.
I have a "94" apv. The fuel pump is in the fuel tank and is one of the simpler ones to replace,and reasonably cheep at $60.
In the fuel tank
In the fuel tank
It is inside of the fuel tank.
In Chevy Lumina
There will be possible symptoms of a faulty fuel pump. Some of these symptoms could be the following:\n. \n1. Engine stalling or pre-stalling\n2. Loss of acceleration while d…epressing the accelerator\n3. Engine cranks, but no start.\n. \nThe main condition to look for is symptom #3. A faulty fuel pump is present when the following conditions exist:\n. \n-There are no air leaks. The intake and vacuum hoses are intact.\n-There are no fuel leaks. The fuel lines are in good condition.\n-The fuel injectors are clean and in good condition.\n-The fuel system is clean with no corrosion or damage.\n-The engines electrical components are safe and intact.\n . The engine cranks, but does not start.\n . \nYou will need a new fuel pump mainly if the engine cranks, but does not start. In order to maintain a good fuel pump, make sure the fuel system is regularly cleaned. Good routine maintenance is a good habit.
In Chevy Lumina
in the fuel tank.
In Fuel Filters
The fuel pump is located in the fuel tank (gas tank). Usually you need to pull the fuel tank out to replace the fuel pump