go under your car and there you should see the exhaust pipes running towards the back. they are both next to each other, and the oxygen sensors are screwed directly into the exhaust pipes. usually there is 4 of then. on both pipes, one is for the upward oxygen flow and the other for the downward flow. sometimes they are hard to get out but relatively easy to replace. make sure you also check your head gasket, because oxygen sensors sometimes fail if the gaskets are blown! good luck
On a 1999 Ford Explorer : Bank 1 is the passenger side of the engine ( 4.0 EFI / 4.0 SOHC / 5.0 V8 )
The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter
The oxygen sensor is located in the exhaust manifold near the firewall. It is easier to get to the sensor from under the vehicle.
Where is the DPFE sensor located in a 1999 Ford Exployer? I had my oil changed yesterday and was told that the hose connected to this sensor is off.
The oxygen sensor on a 1999 Honda Civic is located on top of the catalytic converter. The catalytic converter is under the car.
The upstream oxygen sensor is located in the exhaust pipe between the exhaust manifold and the catalytic converter The downstream oxygen sensor is located at the catalytic converter outlet
I'm not a mechanic / technician but I assume that would be : Bank 2 , sensor 1 Bank 2 is the drivers side of the engine in a 1999 Ford Explorer Sensor 1 would be the oxygen sensor somewhere in the exhaust before the exhaust enters the catalytic converter ( upstream sensor )
I'm not a mechanic / technician but on a 1999 Ford Explorer 4.0 L Over Head Valve V6 engine , bank 1 is the passenger side of the engine and I BELIEVE the oxygen sensor is in the outlet of the exhaust manifold
How many oxygen sensor on your 1999 3.5 rl?
The oxygen sensor on the 1999 Oldsmobile Cutlass Sierra is located on the lower exhaust. If you need to replace it, they are available for about $20 online.
They are located on the passenger side. Sensor1 is right past the exhaust manifold, and sensor 2 is after the cat.
the iat sensor is located in the air intake duct this is the large rubber hose that attaches to the air filter box