where is the heating element on a kenmore series 400
Yes heating element is burner assembly.
the heating element is gone out
it is a super capacity
The rated capacity of a Kenmore Series 80 clothes dryer is about 3.5 cubic feet. That will usually translate into about 28 pounds of wet laundry.
The rated capacity of a Kenmore Series 80 clothes dryer is about 3.5 cubic feet. That will usually translate into about 28 pounds of wet laundry.
It could be caused by a damaged heating element. You should have the heating element checked by a professional. Try cleaning the dryer first. Remove lint clogging the exhaust vent. Overheating in the washer might cause the heating element to shut off safely. Also check if the dryer is plugged correctly.
Approximately 7.37 cu. ft. for the dryer and 3.64 cu. ft. for the washer.
The heating element is on the bottom in the back, if you pull the front base panel off, you can look back and see the element against the back of the dryer. You can undo two screws and pull the element out. "MAKE SURE TO UNPLUG THE DRYER FIRST SO YOU DO NOT GET SHOCKED" Jeremy
The heating coil/element has probably gone out.
Actually it depends upon the type of dryer. So according to ur model no contact ur dryer dealer.
$250.00
Simplest solution would be the igniter or glow bar at the burner or the sparker if it has that. You should be able to take off the lower panel or there is a site plug that will let you see the burner.