the knock sensor is under intake, must remove intake and it is under two coolant lines.
can you tell me where the knock sensor is located on a 3.3l mercury villager
the elictronic control sinsor at on a 93 mercury villager
The knock sensor is located - are you ready for this? - in the valley of the engine under the intake manifolds. Both upper and lower manifolds must be removed to gain access.
This is an image. (below)
It is under the intake manifold.
The knock sensor is under the intake manifold, which has to be removed. This should be left to an experienced mechanic.
1999 - 2002.
I payed $117.00 at auto zone
There's no need to replace knock sensors, and there was never a 3.6 engine.
the knock sensor monitors preignition,spark knock and sends signal to pcm,pcm responds by adjusting ignition timing and fuel timing until knock is gone.
It is under the intake manifold. Darn hard to get to and expensive to change.
donde esta colocado el knock sensor en una Chevy silverado 2000