answersLogoWhite

0


Best Answer

Most knock sensors are located in the block on the firewall side. Should be the only sensor with two wires in the block. It will also have a camshaft position sensor as well.

Hope that helps. I am not educated on Mazda engines.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the knock sensor located on a 1999 Mazda Millenia 2.5 engine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the module located on a Mazda millenia 2000 2.5l?

how to change speedometer sensor on mazda millenia 2000 2.3 v6


Where is the water pump located in a Mazda millenia?

where is the water pump located in Mazda millenia


Where is located speed sensor on Mazda millenia s?

On the transmission output shaft housing on the side closest to the firewall.


What liter engine is in Mazda millenia 2001?

The millenia P - has 2.5 liter engine, The Millenia S has a 2.3 liter engine


How many coils do a 2000 Mazda millenia s have?

a Mazda millenia with a miller cycl engine 2.3 engine has 6 igition coils


Is Mazda millenia and Mazda 626 have the same engine?

The 626 and the Millenia share the same 2.5 liter engine,the only difference being the version in the millenia makes more power.


How do you reset the 'check engine' light once an 02 Sensor has been replaced on a '95 Mazda Millenia?

you need an on board diagnostic scaner


Is the 1999 Mazda millenia have an interference engine?

2.5L V-6 Mazda Millenia engine is a non-interference engine. If your timing belt pops, you will not damage your valves, like I did in my Diamante


Where is bank 2 sensor 2 on a Mazda tribute?

The bank 2 is located on the driver side of the engine on the Mazda Tribute. The Sensor 2 is located after the catalytic converter.


Where is the knock sensor located and how hard is it to replace on a 2001 Mazda Millenia?

29's here i have a 97 Mazda millenia 2.5 and have had the knock sensor replaced. all the Mazda 2.5 motors 95-02 are the same so i can tell you that its located in the center of the engine only accessible from the top of the motor underneath the intake and fuel rails (which have to be removed in order access the sensor). the gasket for the intake can not be reused and must be replaced. this a repair that a standard mechanic should be able to perform. hope this helps. It is underneath the supercharger support bracket on the 2.3L.


What does the s denote on a Mazda millenia?

The S denotes the 2.3 Supercharged engine one the Mazda millenia (rather than the regular 2.5)


Where are the Oxygen sensors for Mazda millenia and how many are there?

Depends on Which Year and Which Engine (2.3 or 2.5) My 99 2.5L has 4 o2 PLUS a knock sensor