The map sensor on a Chevy venture is located under the ignition module on top of the rear cilinder bank. To access it you have to remove the ignition module.
It helps a bit if you rotate the engine forward and you can lower the engine for about 4 inch. you will have to unbold the subframe on the frontside, use a hydraulic jack to take the weight and lower it carefully. this gives you the extra space needed to work on it.
Where is the camshaft sensor located in 1997 Chevy venture
Where is located pressure sensor on Chevy Malibu 1999
The 1999 Chevy Suburban camshaft sensor is located on the front of the engine. The camshaft sensor will be behind the front engine cover.
on my 2000 Chevy Venture, it's the one that sits pretty much on the top of the belt drive.
the 1999 Chevy venture does not have distributor cap, he has a electronic module assembly, assembly is module and three coils, they are located on the top of the engine, back in the medium near of the firewall.
On the 1999 Chevy Silverado Z71 4WD, the speed sensor is part of a module. It is located next to the transmission housing.
it is located next to the crossover pipe for the exhaust. you have to remove it to get to the thermostat housing.
i like an axhaust diagram for a 1999 chevy venture
On your 1999 Chevrolet Venture, the Flasher is located: Below the instrument panel, left of the steering column.
i was wondering how to change rear brake drums for 1999 Chevy venture
its on left side of trans behind side pan
it's built into the computer.