It is possible there is a problem in the dash board that reads the output of the sensor. You may need a "cluster" which can be purchased from a junk yard / parts recycler cheaper than a new on at the dealership.
how do you replace coolant temp sensor on a rodeo
Has just the sensor been replaced or the plastic drive gear in the trans as well The drive gear often wears uneven causing the speedo to go inop
En donde esta localisado el sensor de coolant en la isuzu rodeo 2002 4 cilindro
the sensor is in the back of the rear differintial u need to check the wires running back by the right rear tire for breaks as this problem was apparent on my own 1993 rodeo other than that the sensor unplugs from the harness and is very easy to remove and replace
Could be in the trany sensor/gear or the speedo itself
that depends on the model year of the rodeo. If its a 92/93/94 remove the guage housing module(see how do i remove the dash board of a 93 rodeo) Once the module is out the front and rear panels of it will pop off with a screwdriver and you can replace the bulbs.
The fuel level sensor can only be replaced by first removing the fuel tank. it then can be easily removed from the top.
replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo replace water pump on a 1994 rodeo 6 cylinder
Under the car by the drivers seat that's the first thing i had to replace on mine
Not long at all should take no longer then 5 mins
on the left side of the transmission is a sensor. carefully remove it and pump/squeeze fluid in that opening up to the bottom of the hole. replace sensor.
oxygen sensor