Not long at all should take no longer then 5 mins
It is located between the camshafts right behind the camshaft pulley's.
it does not have one, after 2000 modes the camshaft position sensor is eliminated the these vehicles use the use the VRS system to determine where the No. 1 piston is. therefore they only required a Crankshaft sensor not a Camshaft sensor.
PO341 Camshaft Position Sensor Circuit Range Problem
How fixed camshaft sensor circuit low input
On the drivers side head..rear of the head directly behind the intake manifold
please help
the camshaft sensor is at the front of the engine next to the radiator, it is held on with one 10mm bolt and is in the middle of the plastic cambelt cover (this does not need to be removed). unclip wire remove bolt and pull.
It is a Throttle Position Sensor
how do you replace coolant temp sensor on a rodeo
On 97 & earlier it's located on the front left upper corner of the timing belt cover (3.2L). 2.2L it's on top of the front part of the cylinder head between the camshaft sprockets.
If this is a 6VD1 engine, the camshaft position sensor will be located on the very back of the left bank head (on the inside, under the intake manifold). The easiest way to have it replaced or removed is to take off the intake manifold. The sensor is only secured with one 10mm bolt but it is a frustrating thing to put it back on with the intake installed, unless you have very slim hands.
look at the top of the engine, the cover for the spark plugs ends at the front of the engine. Right at that point is where the connector is, to get at the sensor you must remove the serpentine belt, wiring cover, and timing belt cover, and the sensor bolt can be accessed between the camshaft pulleys, its a small torx bolt.