Fuses That "Blow" Repeatedly
Without being able to "hands on" troubleshoot the circuit served by the repeatedly blowing fuse, no one can identify the specific cause/defect which is causing your problem.
Therefore, the following generic answer can be applied to any electrical circuit, whether in a vehicle, or in a building, or whether alternating current [AC] or direct current [DC].
Fuses [and Circuit Breakers] are safety devices designed and installed in electrical circuits TO PROTECT the conductors [wires] and other components from short circuit conditions and/or overload conditions which cause an extremely large flow of electrical current [measured in Amperes], which causes overheating of the conductors that results in damage to the insulation and the conductors.
And in a worst case scenario, the probability of a FIRE which could destroy the vehicle, house, or other structure in which the circuit is located.
When a fuse or Circuit Breaker [and replacement fuses, or "tripping" Circuit Breakers] "blow," especially if it happens repeatedly, is an indication of an UNSAFE CONDITION in that circuit, usually a short.
The fuse or circuit breaker is doing what it was designed, intended, and installed to do, protect the conductors and components of the circuit which it serves.
The proper "fix" is for a qualified technician, who knows what he or she is doing, to troubleshoot the involved circuit, find and identify the defect, and make proper repair [s], BEFORE replacing the fuse again [with the properly sized fuse or before resetting a circuit breaker].
Some ignorant few will suggest installing a larger fuse or breaker to solve the problem, BUT that will only increase the hazard, not correct it. Do not follow "bad" advice by installing a larger fuse in a misguided attempt to correct the problem. To install an over-sized fuse would almost guarantee damage to the wiring and an electrical system fire.
Fuse panel.
What would cause your fuse to blow when you turn on your lights on your 1993 mazda 323 the fuse to the tail lights on dash lights blow?
Tail light assembly short
There is an over-current condition in the tail light circuit. It could be a short to ground or a bad bulb.
The dash lights and the tail lights are on the same fuse. In all probability, you have a short circuit in the tail light wiring.
Did you check the fuse box? Sounds like a blown fuse to me.
Tail light fuse is blown. It also feeds the 5 amp dash light fuse. Also check for shorts causing the fuse to blow including the license plate light.
not sure not sure
Probably blew the tail light fuse. It also feeds the five amp dash light fuse also.
There's a short in the wiring of your vehicle somewhere causing the wires to cross and blow the fuse.
I think its on the driver side there should be a panel on the right hand side near the excellerator
The tail light fuse is located in the fuse box which is located in the glove compartment. The tail light fuse will be a red wire.