The air filter may be plugged up, replace it.
You need to check the up stream or dirty side of the intake system
The oil filter is located at the bottom of the engine. It can be remove with an oil filter wrench. Do not remove the engine top cover unless you need to repair something very major.
Just remove plug bottom of pan to drain. Replace filter (hand tight) You may need oil filter wrench or strap to remove old one. Fill to proper level on stick thru cap or breather valve cover.
Remove glove box. Remove cabin air filter cover. Replace filter. Put cover back in place, then the glove box.
This is for a Cabin Air filter. Open the glove box. Remove the plastic access cover from back of the glove box by releasing the tab and pulling the cover from the right side toward the seat. Then remove the filter cover by releasing the two (2) tabs, one on either side of the filter access cover. Then remove the filter by pulling the filter straight out and replace.
To remove a valve cover on a 1998 Suburban, you need to take all of the valve cover bolts out. Lift the cover slightly, then see what is in the way of sliding it out (hoses, fuel rail, etc..) Remove and items blocking the removal then lift the cover off. Make sure to clean the cover and head of all old gasket material before installing a new gasket and bolting the cover back on.
Remove the air filter housing cover. The air filter will lift out. Drop the new air filter into the housing and replace the cover.
The fuel filter for the Corolla 1.8L is located inside the fuel tank. Remove the lower portion of the rear seat to expose a cover. Remove the cover and pump/filter assembly to gain access to the filter.
Should be able to remove the inspection cover and look at it.
1: Loosen the 2 clips on top of the filter housing & lift the cover tabs out of the housing. 2: Push the filter cover toward the engine. 3: Remove filter & replace with new one. 4: Installation is reverse...
You will have to remove 1 valve cover.
The fuel filter is located on the top of the engine near the front of the engine. To access the filter you must remove the engine cover that says 7.3l powerstroke. That cover is fastened with two plastic nuts. To remove the filter you must remove the plastic filter cover which is circular and approximately 3 inches in diameter. That cover screws into the filter housing. Before changing the filter you should drain the housing which is done by opening the drain valve directly behind the filter housing.