0
You washed your mobliser of your jeep now it wont start what can you do?
Wiki User
∙ 12y ago
Mobliser? I assume you are wanting to say that you opened your hood and washed the engine? If this is correct then you probably got water into electical connections and shorted something out. This would be especially valid if you used a car wash or power washer with water under high pressure. If that's the case then you could have damaged just about anything under the hood. Generally speaking, high pressure water under the hood is usually a bad idea.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
I washed the engine on a 1994 Jeep Cherokee. Now it wont start.?
you flooded it
Why wont 96 Jeep Cherokee Sport start?
probably cam positionong sensor.
Help my 2002 Jeep Liberty won't start?
What is it doing? ddus it turn over but just wont start?
Trouble starting 1996 Jeep Grand Cherokee?
hard or wont start after and during rain
Why wont my 96 jeep grand Cherokee start.?
Does it turn over? Does it have fuel, spark and compression?
Jeep wont start in park or neutral COULD IT BE A NEUTRAL SAFETY SWITCH?
Yes, this is possible.
Why wont 94 jeep grand Cherokee limited 5.2 wont start and no spark after changing transmission?
somebody broke or didn't connect the crank sensor
1986 Jeep Cherokee 2.8l won't start even pouring gas in carburetor?
ok i have a 1986 jeep cherokee it wont start from the key in side it turns over but dosent fire up an its got (gas an fire) it will start if you pull start it an it has a carb
What if your 1990 Jeep Wrangler wont start?
The engine needs good battery power, fuel and spark to start and run. You are missing one of those.
My jeep wont start I went mudding and it worked fine. The next day my jeep wont start I look at the passenger side and its flooded with water. It has been raining like crazy. its a 97 wrangler man.?
Go get a new one... Its ganna cost more to fix then just to get a new one.
What would cause your 1993 Jeep grand Cherokee Limited 4.0L inline 6 to not start?
on the 4.0 jeep, if it cranks, but wont start, try replacing the crank sensor, located at the top rear of the engine, at the transmission
Why my 1970 xs v-12 wont fire after engine getting washed?
Ignition problem probably, Check wires, coil & cap to start
