0
You went to crank your car and your keys just turn all the way around what might be the problem 1991 Chevy Lumina?
Wiki User
∙ 15y ago
it means that your ignition is broke,you can purchase it yourself and then take it to a repair shop for them to apply.this will save you money and avoid the mark up price.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Your 1992 Chevy Lumina is turning but want crank what is it?
My 1990 Lumina 3.1 had the same problem and it was caused by the crank sensor.
Crankshaft sensor for a Chevy Lumina?
Where is the crank sensor on a 95 chevy lumina car ?
How do you replace the window crank on a Chevy lumina 1997?
Remove the inside door panel of your 1997 Chevy Lumina. Remove the linkage to the window crank. Remove the window crank retaining bolts. Reverse the process to install the new window crank.
Where is the crank sensor on a 95 Chevy Lumina?
Behind the harmonic balancer.
Where is crankshaft sensor located on 1992 Chevy lumina?
That year model did not use are have a crank sensor.
Where is the crank sensor on a Chevy Lumina Z34?
what year? and what size engine? crank sensors are in different locations based on year and engine size.
How do you remove crank pulley 92 lumina van with 3.8?
I want to take off the pulley wheel off,from a 1992 chevy lumina apv van.
1996 Chevy lumina van will crank has no problem with the coils new spark plugs timing belt ok but not firing?
Check to make sure there is power going to your coils from your ignition switch.
Cost to repair crankshaft position sensor in 1997 Chevy lumina?
Just had this done on my 97, along w/ other work. It cost me around 325.00 for the crank sensor.
Where is the crank shaft position sensor on a 1995 Chevy lumina 3.1?
RH SIDE OF ENGINE AT END OF CRANKSHAFT
Why won't your 1990 Chevy Lumina turn over?
I own a '96 Chevy Lumina that has the same problem and it sounds like it is a fairly common problem. I don't actually have the solution, however I know that if I turn the car to the on position and sit for a couple of minutes, then try and crank it over, it will magically start. I was thinking maybe there is just a bad connection or wire somewhere in the ignition system.
How do you fix a 1992 Chevy Lumina that starts and drives but dies each time you slow down to stop?
I have a 92 lumina euro that did that and it turned out to be my crank sensor. The problem could also be the Torque Converter Clutch, bad plugs and wires, distributer cab, low idle could cause this to.
