P0456 EVAP Leak Monitor Small Leak Detected. You have a leak in the fuel EVAP system. Finding these very small leaks can be very challenging. You may want to take it to a professional.
No fuel (out, or pump not pumping) or no spark (or really bad timing).
Physically has a turning problem ? Try your spare key and still has the problem? Replace the ignition switch.
The ignition on a Chevrolet Cobalt will not turn with the key if it is does not correct align inside. This will block the cylinder from turning and prevent starting.
Turning my ignition on and wont turn off because it is faulty.
Dead battery if it is having trouble turning over or the starter motor is going out. Check the battery cables and ground straps at both ends for corossion
Answerapply the parking brake before turning the ignition/starting the motor. OK, so how do you reengage it?
There is a long black thing on your keys, shake your keys in the ignition and dash should light up .
I have a 2000 Olds Silohuette. I just reset the "Change Oil" light by turning the ignition to on(DO NOT START THE VEHICLE), pushing the accelerator down to the floor 6 times, turning the ignition off, and then starting the van. The light did not come on. Hopefully this will help.
So it would seem. If the ignition is in the column it may also be jammed by the steering wheel lock. Try turning the steering wheel and holding it while turning the ignition key.
The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.
With the ignition OFF press and hold the odometer reset button while at the same time turning the ignition to the on position without starting the engine. After 5 seconds the light will reset.
With the ignition OFF press and hold the odometer reset button while at the same time turning the ignition to the on position without starting the engine. After 5 seconds the light will reset.