0
Your bike makes a popping sound in the first two gears what could it be?
Wiki User
∙ 14y ago
It could be many things... engine, tranny, chassis...
My guess is that in first and second gear you are accelerating the hardest, so compression is my suspicion. Head gasket or exhaust. They can both make similar funny noises...
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Your car accelerator plate makes a popping noise when you press down on it?
If by "popping noise" you mean backfire, it could be crossed ignition wires, or some sort of misfire.
What makes your engine shake when you shift gears?
Engine mounts could be loose or worn.
What does it mean when a 04 Nissan sentra makes a popping noise in reverse while turning?
could be a contant velocity joint
What makes a clunk or popping sound when turning wheel sharply?
Most likely a CV joint...could be dangerous... consult a mechanic asap
When starting a 1999 Chevy Tahoe it makes a popping noise from outside the car and smoke can be smelled but not seen in the ac vents what could this be?
Could be your exhaust system specically your converter.
What gas makes a popping noise when you light it?
The gas making the popping noise is hydrogen.
Why does a propane regulator makes a popping sound?
the spark breaks the speed of sound
Whenever i give my ATV throttle it makes numerous pops what could it be?
bad plug or bad gas or timing could be off carb needs to be cleaned and or adjusted check timing last but it could also be your starter solenoid if the connections are slightly loose, on my predator had same problem constant popping, just be sure to check the solenoid first
What is the name of the cereal that makes a popping noise when you put it in milk?
Rice Krispies IHTH :)
What makes popping corn pop?
Internal steam via a microwave or heated pan.
What makes a clock tick?
A clock ticks because of the gears moving.
1990 Grand Plymouth Voyager cuts out and dies for no reason makes popping noise and stalls on highway and on street?
IT sounds like the Voyager could be losing power to the ignition circuits. Check the crank position sensor first. Make sure that the wiring connections are not loose or corroded.
