most starters have 3 ,but then again this is a 81 I would say 4
Three bolts hold it to the engine.
Locate the starter at the rear of the engine on the passenger's side. Unplug the wiring. Remove the bolts that hold the starter. Remove the starter.
2 or 3, depends on engine.
There are 2 bolts that hold it to the rear of the engine.
the solenoid is ontop of the starter motor which is located at the bottom right of the engine.. 3 bolts hold it in...
The number of bolts holding the starter on an engine can vary depending on the make and model of the vehicle. Typically, most starters are secured by two to four bolts. It's best to consult the specific service manual for your vehicle to get the exact number and specifications for your starter installation.
2 bolts hold it on
its usually on the right side between the engine and transmission, 3 bolts hold it on
what size are the bolts that hold a starter on a 1995 f 250 powerstroke
The starter is located between the engine and the firewall towards the bottom. There are 3 bolts that hold it in place. zx2 2002 model.
Its on the transmission by the back of the engine, on the drivers side. Its held in by 2 bolts that also hold the transmission to the engine.
There are 2 bolts that hold the starter in place and 2 nuts that hold the wiring to the solenoid.