Just hover your mouse at the top border of the Task bar and you should see the mouse cursor turn into an up-and-down arrow. Left click and hold and drag the bar to the bottom of the screen.
FromCommand Mode :set nu Display line numbers
t
There is a command line at the bottom of the screen. This is where the prompt is to type in commands.
press control and the dash line (-) and it turns small again! :)
A small line engraved on the dipstick near the bottom of the dipstick will show FULL
Im not sure but i think its the battery. If the laptops not plugged into the charger I think itll blink.
When the text you type is too large to display in the screen the word processor will take a new line to display the text if Word Wrap is enabled. Otherwise the text continues on the same line and to view this text you would have to scroll horizontally.
It will run (I have done so myself), but requires a custom skin or command line edit to display properly on the small screen. Both of these can be found easily via your choice of search engine.
You half to place the unit in 4:3 mode since the sidebars are being produced from the On Screen Display chips; the EEPROM chip is responsible to get any cxolor on screen!
hoo
It could be a frequency chart.
Assuming CRT type display then when a black part is shown then if you just look at the black part with the rest of the picture covered or sheilded then you will see that the black is still grey or same as when tube is not illuminated. Bottom line-- no such thing as black on screen , only black compared to rest of picture ! I invite you to try it ! Pete