The engine case is split, correct? Having a magic marker, bottle of nail polish, or whatever will make this job easier, but it's not mandatory. For extra entertainment, go buy your nail polish with your hands all covered in grease. Anyway! Look very close at your camshaft's gear and you will find one tooth that has a very distinct little dimple machined into the side of it. On the crankshaft's gear, you'll find two teeth with these dimples in them. The one marked tooth on the cam gear fits between the two marked teeth on the crank gear. It's best to paint the sides of these teeth because, when you put the case together, those little dimples are very hard to see.
1600cc
remove the timing cover and mark the belt and pulleys with liquid paper then transfer the marks onto the new belt piece of cake good luck
Two and a half quarts.
The ones sold in the US had the 1600cc engine that became standard in 1970.
Start the engine and point the timing light at the timing marks. The flashing timing light will cause the timing mark on the harmonic balancer appear to be stationary and aligned with the timing marker. It should be lined up with "10 BEFORE." If not, turn the distributor until it is. Turn off the engine and tighten down the distributor hold-down. Unhook the timing light. Read more: How to Set the Timing on a 1974 Dodge 318 Motor | eHow.com http://www.ehow.com/how_7405118_set-1974-dodge-318-motor.html#ixzz2S9e9ResE
Damon Marks was born on 1974-10-06.
Melville Marks Robinson died in 1974.
i dont know of any engines that started with AD however type1 AE 1971/72 1600cc - dual relief, dual port AH 1973/74 1600cc - 8mm head studs with case savers AJ 1975-1979 1600cc - fuel injected type2 AW 1973/74 1800cc - dual carb. AW 1975 1800cc - fuel-injected AP 1974/75 1800cc - European only type 3 AN 1974 1800cc - 8.6:1 compression AT 1974 1800cc - European only, dual carb.
Larry Marks - American football - died in 1974.
The base ignition timing for a 1974 Chevy 454 engine is between 8 and 12 degrees below top dead center. A timing light is needed to accurate set ignition timing.
Impact gun/wrench and a puller
counter clockwise