Carburetor- Side of the block with fuel lines running in and out of it. Disconnect, unbolt, remove, replace, reconnect, have fun getting it started again.
Fuel injection- Drop the fuel tank, disconnect the stuff plugged into it, unbolt the panel that has tubes in it. take out the fuel pump, remove and replace, reassemble in reverse order
The Ford Bronco is categorized in one of five generations, with the 1986 model falling within the 3rd generation. The base curb weight of a 1986 Ford Bronco is approximately 4374 lbs.
what is the question?
The base curb weight of the 1986 Ford Bronco is 4,374 pounds. This is for the 4.9 liter North American version.
A 1986 Ford Bronco II would use R12 unless it has been converted
no.
yes you may have to inter change a few things but they will fit
i need a full picture view for the removal and instillation for a radiator for a 1989 ford e150 van 5.0 engine
Is there just a gear or a timing chain on a 1985 ford bronco 11 2.8 liter V 6.
http://broncograveyard.com/
33 gallons
about 13 quarts.
yes just make sure to align everything so it all works properly