Emergency procedure:
Hi, I assume that this is a regular tie rod. The removal will require some brut force. There is only one nut holding the tie rod end to the wheel but even when you remove it the tie rod end will not come off. To get it off you should Slacken the nut, DO NOT remove the nut completely, then use a big hammer and hit the metal holder into which the tie rod end is fitted (i.e. the metal that protudes from the wheel/hub) After a few blows the tie rod end will become free. You can now remove the nut and take the tie rod out.
For a less violent approach:
Some places like autozone will lend you a puller that is easy to use, or a 2-prong slanted fork
This model has mechanical linkage in the door so you just have to keep trying to hook the lock rod. It's not really hard but you have to just keep trying.
Rod Laver Arena was created in 1988.
Hot Rod - video game - happened in 1988.
Hot Rod - video game - was created in 1988.
20680 - Removal of implant; deep (eg, buried wire, pin, screw, metal band, nail, rod or plate)
On the rear Rod and's, in your 1988 Chevrolet Corvette, are located on the axles. A complete diagram of the grease fittings can be obtained from most auto-parts stores.
Rod Allen debuted on April 7, 1983 and played his final game on October 2, 1988.
Remove the sun visor retaining screws. The sun visor will slide off of the sun visor rod. Lubricate the sun visor rod. Put the sun visor back on.
Remove wheel and properly support vehicle. Remove outter tie rod from steering knuckle. Remove outter tie rod, count how many turns it takes to remove from inner tie rod. Remove inner tie rod boot. Use inner tie rod tool to remove inner tie rod. Install new inner tie rod (with inner tie rod tool) and do not overtighten. Properly install inner tie rod boot (you can use a zip tie on part that attaches to rack). Install outter tie rod and use the same amount of turns that you counted during removal (this will help with alignment). Install tie rod to steering knuckle and use a new cotter pin. Put wheel on and get an alignment.
You need a removal and installation tool, usually harborfreight.com has one.
there are screws at the base of rod right next to the doors. remove them and your in business.
i would like a diagram and instructions on how to change inner tierods for a delta 88 1988