Mercedes-Benz 190-Series

The Mercedes-Benz 190-Series is one of the most coveted of all Mercedes-Benz cars. The series is known for its stability, safety, durability, and luxury. Some popular Mercedes-Benz 190 models include the 190b, 190e, 190c, 190Db, and the W121.

1,718 Questions
Car Batteries
Mercedes-Benz 190-Series

Battery location of Mercedes-benz B class?

Under the passenger carpet

219220221
Mercedes-Benz
Mercedes-Benz 190-Series
Mercedes-Benz 200-Series

What is the full meaning of Benz?

There are 57 varieties of Benz

177178179
Shotguns
Remington Firearms
Mercedes-Benz 190-Series
Ford Escort Diesel

How do you remove the barrels of a Stevens 311 shotgun?

I am in the final stages of completing the restoration of a model 311a 12 ga. The disassembly of your 311h 20 ga should be identical. That is to first be sure the gun is unloaded, after this has been ascertained the action is closed. At this point the forearm can be removed by placing the tip of the index finger between the front of the forearm and the barrels and pulling down. After the forearm is removed press the breakdown lever to the right which will unlock the action at which time the barrels can be lifed off the receiver. At this point you may remove the butt stock by removing the 2 screws in the butt plate and taking a long flat point screw driver and removing the stock bolt. Be careful when you are removing the butt stock and pull it directly to the rear. Hope this is helpful.

109110111
Mercedes-Benz 190-Series
DIY Projects

Where is the vacuum pump in Mercedes 190D located?

I'm not positive about your diesel but my gas model is under the back seat on the right side in a foam box presumably for noise damping.

99100101
Pontiac Sunbird
Mercedes-Benz 190-Series
VW Golf
DIY Projects

How do you change the pollen filter on a 93 Sunbird?

There is no pollen filter on any sunbird the oldest GM product to get one is a 1993 Cadillac

878889
Mercedes-Benz
Mazda Protege
Mercedes-Benz 190-Series
Flooring

How do you replace the floor boards of a Mercedes?

There are some companys that make floor pans that can be installed in such situations however most of these pans need to be welded in and sealed. Most all body shops can help you in this situation. , EzForJesus

868788
Mercedes-Benz
Mercedes-Benz 190-Series

How do you adjust belt tensioner on 93 Mercedes 190e?

Lossen 17 mm bolt at botton of tensioner and screw 13mm bolt on tensioner stud untill belt is tight then re torque 17mm bolt !!

737475
Electric Windows
Mercedes-Benz 190-Series
Ford Explorer XLS
Ford F-150

How do you replace the switch and motor of the driver's window in a 1991 Mercedes 190E?

tools required: spanner (10mm i think) and Phillips screwdriver

remove the plastic covering of the door locking mechanism remove the plastic cover of the door armrest (at the top) to reveal a bolt. Undo this bolt.The whole door facia/panel will lift up a bit although the door handle although the door handle mechanism is still attached. This can then be unhooked more easily.

The motor is held on by 3/4 nuts (and tension). undo all these and push the motor mechanism and sliders back into the door frame. (support the glass carefully at this point)

the motor is attached to the frame by sliders and can be separated relatively easily.

refitting is the reverse

697071
Mazda
Mercedes-Benz 190-Series
Mercedes-Benz C-Class
Ford Transit

Where are the vin numbers located on a Mercedes?

There should be 3 locations. 1, at the front left (drivers side) of the windshield, in the bottom corner, can be seen from the outside of the car. 2, drivers side door jam, can be seen once the drivers side door is opened, on the b-pillar. 3, One that nobody really knows about, but there is also one behind the rear license plate, on the trunk lid.

414243
Isuzu Rodeo
Mercedes-Benz 190-Series
Locks and Latches

Where is the hood release on a 1992 Volvo?

Just under the left side of the dash!

656667
Spark Plugs and Wires
Timing and Firing Orders
Mercedes-Benz 190-Series
Ford E-150 Van

What is the spark plug order on a 1997 Ford e 150?

If it is a 5.4l, there is no order. It is a coil on plug engine, and it would be very hard to mix the coil positions up since the wires aren't very long. Most likely if it isn't a 5.4l, it is still coil on plug on 97 on up. I agree with the other answer too. Go to your local parts store and buy a Haynes manual. It will help you out in more ways then one.

This type information can be easily found in your owner's manual. If you do not have one, I suggest you get one. Dealer can order you one or you may find one at a salvage yard. Also search on line for a down loadable copy. Some manufactures do have these on line. Also look on the intake manifold.

646566
Serpentine Belts
Mercedes-Benz 190-Series
Mercedes-Benz 300-Series
Mercedes-Benz E-Class

Do you have a serpentine belt diagram for a 1986 190e Mercedes?

You already have one. Under the hood on a placard & possibly in your owner's manual.

636465
Steering and Suspension
Power Steering
Mercedes-Benz 190-Series

How do you discover the correct power steering fluid for a Mercedes 190E if you don't have the owners manual?

Contact a Mercedes dealer. Febi/bilstein Part# 08972 comes in 1 liter bottles. The power steering capacity is 0.6 liters(0.6US qt)for a 1990 190E 2.6

626364
Car Stereos and Speakers
Mercedes-Benz 190-Series
Toyota Camry
Honda Accord EX

Can someone give you a wiring diagram for the stereo wires so you can change to an aftermarket CD deck?

I just got this off another web site. It said it was for a 190E. I'm not sure if it's right yet, I guess I'll find out when I work on my radio in the morning. Memory (+12v Constant) Red Ignition (+12v Switched) Black/Yellow Ground (-) Brown Illumination Gray/Blue Dimmer (none) Power Antenna Blue Speakers Right Front (+) Black/Green Right Front (-) Black Left Front (+) Black/Red Left Front (-) Black Right Rear (+) Black/Green Right Rear (-) Black Left Rear (+) Black/Red Left Rear (-) Black

626364
Spark Plugs and Wires
Mercedes-Benz 190-Series
Honda Accord EX

What is the spark plug wiring diagram for a 94 honda accord?

start from far right spark plug hole to the far right bottom distributor then the next one to that spark plug cylinder to the left of the distributor you just did then the next cylinder across the the closes one last one right next to it should be the location

616263
Mercedes-Benz 190-Series

Mercedes-Benz 190 Engine Control Wiring Diagram?

computer control

616263
Mercedes-Benz 190-Series
Mercedes-Benz E-Class
Heating Ventilating and Air Conditioning

190E coolant overflows after 10 mins of engine running coolant light comes on rad fan seems fine also cabin heating is not working -only cold air availabe what could be wrong?

I would suspect a stuck thermostat. Time for a complete cooling system maintenance. Drain and flush the system, replace the thermostat, check and replace any defective hoses, refill with a 50/50 mix of the proper coolant, bleed the system with the heater thermostat at high heat, and see where you stand then. Also make sure the cooling fans are operating properly.

606162
Mercedes-Benz 400-Series
Mercedes-Benz 190-Series

How do you remove blower motor Mercedes B 190 E?

its under the windshield mono-wiper remove front air cowl at base of windshield and undo i think 6-8 clips to remove the main cover of blower assembly housing then you should have access to the whole works

596061
Mercedes-Benz 190-Series
Plumbing

Why does the bathtub faucet run while showering?

If it is coming from the tub spout then the gasket is moving around or esle it is shot. The easiest way to fix this is to get a new tub spout. It will more than likely take more time to attempt to change the gasket on the spout then to install a new one.

585960
Mercedes-Benz 190-Series

Where is air temperature sensor for a 1988 Mercedes Benz 190e?

Located on the back side of the front license plate holder. Pencil shaped with a long black wire.

575859
Oxygen Sensors
Pontiac Sunfire
Mercedes-Benz 190-Series
Honda Accord EX

How do you change the oxygen sensor on 1988 Mercedes 190 E 23?

Located under the passenger side of the car in the exhaust pipe before the catalitic convertor. The wires go through the transmission tunnel and into the loom under the passengers foot well. There is a plastic relay cover panel under the front passengers carpet, remove this to locate the 4 wire connector for the O2 sensor.

565758
Chevy Impala
Mercedes-Benz 190-Series
Subaru Impreza
VW Jetta

How do you remove the rear seat bottom from a 1990 Jetta?

it's kind of difficult. lift the back side while sliding the front tward the back, it takes some force, well mine did. wiggle it around some and keep pulling up till you get it out.

555657
Cars & Vehicles
Pontiac Firebird
Pontiac Grand Am
Mercedes-Benz 190-Series

What causes a 1991 Mercedes-Benz 190E 2.3 to stall at idle or be hard to start when hot?

Could be a number of reasons. Visit www.mercedes190.co.uk

505152
Fuel Filters
Mercedes-Benz 190-Series
Mercedes-Benz C-Class
Mercedes-Benz E-Class

Where is the PCV filter located on the Mercedes Benz 190E?

If you have a 1989 or a 1990 2.6 Liter automantic transmission Mercedes Benz,then there is no PCV. It has already passed emissions.

545556
Cars & Vehicles
Mercedes-Benz 190-Series
Honda Civic LX

How do you replace the ignition swithch on 1988 190e The steering is lock and turing the wheel is not helping?

you need a good manual (haynes is fine) for this job. i could try to explain it but even after seeing the photos and drawings in the manual i had to take it apart to understand.

short version: remove instrument panel; remove kick panel above driver's legs; remove steering wheel; remove plastic trim cover behind steering wheel under steering column. turn key to 1st (ACC) position and THEN reaching through instrument panel opening, pull wiring harness off back of switch. through instrument panel opening, remove pinch bolt in clamp holding ignition lock to steering column. press and hold spring loaded button that was hidden under clamp and wiggle lock assembly away from column slightly. pry off trim ring around where the key goes in the lock. make sure key is again at 1st position, then stick 2mm dia wires into the 2 little holes opposite each other in rim around keyhole. pull out lock tumbler with key. rotate entire ignition lock assembly as required and pull away from steering column. reach through key opening in dash and pull off electrical connection as it becomes visible. pull vacuum hoses off lock assembly on left. you will swear the assembly won't fit past to come out but it will, barely.

I came across this problem on my dads '87 190e 2.6. To remove the barrel assembly it is necessary to be able to turn the key to the first position to insert the U shaped 2mm wire, however, if the steering lock is jammed up it is NOT possible. The only solution we could find is to cut the assembly in half where the 3 rivets hold the steering lock bolt and ignition barrel/switch parts together with a junior hacksaw and completely replace the unit.

545556

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.