you may want to make sure you have a DUAL(meaning TWO pieces of wire inside the bulb) filament bulb on the brake lights, if you just replaced the bulb and used a MONO filament bulb it will cause this to happen. If this isn't the case, you may want to take it to a mechanic to make sure the sensor that senses when you are pushing the pedal isn't stuck or out that would also cause the same problem.
Because that light is also the same one that signals something is wrong with your service brakes. You need to see a mechanic ASAP
The brake light switch must be broken or out of adjustment. The switch is located above the brake pedal.
what if it don't cut off
The part of the car that turns on the brake lights when you apply pressure to the brake pedal is called the brake switch. Releasing pressure from the pedal causes the brake switch to break its electrical contact, turning off the lights.
If you have the same bulb for brake and signal, brake light power needs to be interrupted by the signal lights, The brake circuit has to go through the signal light switch so the problem could be there.
May be stop light switch--usually located at the upper end of the brake pedal under dash
Have an electrician check the wiring that goes to the brake lights in the trunk of the car.
my brake lights stays on wile driving how can i fix it
The master cylinder contains the reservoir for the brake fluid. This is where you would add it on an 1990 Cutlass Supreme.
It's on top of the brake pedal under the dash.
One of two things. Either the brake light switch behind the brake pedal. Or try wiggling or rotating your turn signal stalk in a circle motion. If the brake lights work when the turn signal stalk is wiggled then you need to replace the turn signal stalk.
Just tell the parts store what type of car you have and they will be able to get you the right pads.
The minimum thickness specs are stamped into the rotors.
Pull the tires off and take the brake calipers off and the rotors will pull off.
Look above the brake pedal on the rod that holds the pedal. There is a button that engages when you depress the pedal to activate the lights. Your parts store will have a replacement and can show you how it is attached.
Is that a question? They work because that's the way your terrible car was designed to work? Do you mean HOW do they work?
Look for a blown fuse.
FRONT OR REAR ?
where is the brake light switch for 1996 Oldsmobile cutlas supreme
brake light on when driving oldsmobile alero