0
1989 cavalier 2L Gas gets to the carburetor but not into it Is there a sensor or just plugged jets?
Wiki User
∙ 10y ago
the ejecter is bad ,itis ontop of the hoseing on clip and it will pop out,
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do you change a Speed Sensor on a 1989 Cavalier Automatic?
Speed Sensor is not working
How do you change the thermostat sensor on a 1989 Chevy cavalier?
where do I find it
Does anyone know anything about 1989 Chevy cavalier carburetor ie gas into carb but not injector?
The 1989 Cavalier is Fuel Injected and does not have a carburetor. The 2.8 V6 is Multi Port FI. The 4 cylinder, I am not familiar with and it may be Throttle Body FI which would look like a carburetor, but if you look closely, has a single injector mounted in the intake plenum. Both engines are FI.
Where is the oxygen sensor in 1989 Grand Prix?
In the 1989 Grand Prix, the oxygen sensor is in the tail pipe. Look for a wire that is plugged into both the tail pipe and the undercarriage of the vehicle.
Where is the O2 sensor located on a 1989 Chevy Cavalier Z24?
on the rear exhaust manifold hard to get to
Does a 1989 Chevy cavalier have a crank position sensor if so where?
its at back of engne just under the manifold
Is there a carburetor filter on a 1989 Chrysler lebaron?
A 1989 lebaron does not have a carburetor.
Where is the Carburetor filter 1989 Chrysler lebaron?
A 1989 lebaron does not have a carburetor.
Is there a tach cable or electrical sensor for 1989 V6 5-speed Cavalier Z24?
its electronic cause of the distributorless ignition.
Where is the map sensor located on a 1989 Chevy cavalier z24?
the map sensor is located on the firewall to the right of the blower motor a small square box with two screws 2 minute job.
What could cause an 1989 Chevy Cavalier to die losing fuel intake after it warms up?
the first thing to check is the manifold air temperature sensor
Where is the crank sensor located on a 1989 Z24 cavalier 5 speed?
back center of the block right above the oil pan it has 2 wires going to the one above it with one wire is the knock sensor
