0
you will have to remove its cover . (pice of the left side of the dashboard.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you remove the ignition switch on a 1989 Chevy Corvette?
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
Does a 1991 crown Victoria tail light fit a 1989 crown Victoria tail light?
Yes, they are identical
Headlight keep flashing on your 1989 crown vic?
could be the the headlight switch, dimmer switch, headlight relay, or a problem with the wiring
Where do you locate the main light control switch located on a 1989 Dakota?
You can locate the main light control switch located on a 1989 Dakota by looking at the user manual.
How do you change the ignition switch on a 1989 Chevy Blazer S10?
You will need to remove the retaining ring from the top of your 1989 Chevrolet blazer ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
Where is back up light switch on 1989 C1500?
On a 1989 C1500, the back up light switch is located on the driver's side of the transmission. It is just behind the area that is bolted to the motor.
Why would your brake light be on 1989 mercury marquis?
Brake light switch stuck, defective, or out of adjustment.Brake light switch stuck, defective, or out of adjustment.
Where is the tail light relay located on a 1989 Toyota Corolla?
The 1989 Toyota Corolla tail light relay switch can be found in the fuse box. The tail light relay switch will be in the third column, second from the top.
Why does my 1989 Ford Crown Vics high beams work and the low beams do not?
Bad bulbs or multifunction switch
How do you replace the alternator on a 1989 Ford Crown Victoria?
basically just remove the bolts holding it up, disconnect the harness, remove and replace!
Where is the fuel pump located on 1989 Crown Victoria?
the fuel pump on the crown Victoria is located in the gas tank and if replacing it you have to remove the tank to get to it...Dennis Sison
Where is the Mercury switch on a 1989 Sundance?
A mercury switch is used for connecting current to a under-hood/hatch light.
