Assuming you have the right key, try wiggling it around a bit int he ignition. Also, try turning the steering wheel side to side as you try to turn the key. The issue is that the tumblers in your ignition switch are probably worn out. This happened in my '94. If you can't turn the key at all, the tumblers will have to be drilled out with a 1/2" bit and the tumbler set replaced.
Bad ignition switch or wrong key.Just replace with new switch about $10.00 NAPA
Set the multi-information display to TRIP A. Turn the ignition switch off. Press and hold the ODO / TRIP switch, and turn the ignition switch on (IG). After turning the ignition switch on (IG), keep holding the switch for at least 5 seconds.
other then taking out the dash board turn your ignition key to acc and it should pop right off. plus if you go to autozone.com and look up ur ignition it will give you directions on how to take it out and replace it
The 1990 Toyota Camry turn signal flasher relay switch can be found beneath the drivers side dashboard. The turn signal flasher relay switch will be above the gas pedal.
Ignition switch 2002 Chrysler sebring. Original key will not turn? Is there a fuse or replace the switch?
Bad Starter. Bad Starter Relay. Bad Ignition Switch. Bad Ignition Module. Improper Ground.
To re-set Toyota Highlander 'maintenance required' dashboard warning light: Turn on the ignition and observe the odometer window. Ensure that it is set on the totalaccumulated mileage of the vehicle (NOT the trip meter). Turn off ignition. With the ignition off - depress the little plastic switch that changes the odometer to the trip meter and then while holding the switch in the depressed position, turn on ignition (it is not necessarry to start the car). Continue holding the switch down for 5-10 seconds and you will see the odometer window flash back to zero. Release the switch and turn the ignition off, and it will be re-set for another 7,500 miles.
how do you change turn signal switch on 1999 toyota camry
Probably wore out ignition key or switch or needs lubrication.
To re-set Toyota Highlander 'maintenance required' dashboard warning light: Turn on the ignition and observe the odometer window. Ensure that it is set on the totalaccumulated mileage of the vehicle (NOT the trip meter). Turn off ignition. With the ignition off - depress the little plastic switch that changes the odometer to the trip meter and then while holding the switch in the depressed position, turn on ignition (it is not necessarry to start the car). Continue holding the switch down for 5-10 seconds and you will see the odometer window flash back to zero. Release the switch and turn the ignition off, and it will be re-set for another 7,500 miles.
Dead battery, loose or corroded battery terminals, defective starter, solenoid, or ignition switch.
To re-set Toyota Highlander 'maintenance required' dashboard warning light:Turn on the ignition and observe the odometer window. Ensure that it is set on the total accumulated mileage of the vehicle (NOT the trip meter). Turn off ignition. With the ignition off - depress the little plastic switch that changes the odometer to the trip meter and then while holding the switch in the depressed position, turn on ignition (it is not necessarry to start the car). Continue holding the switch down for 5-10 seconds and you will see the odometer window flash back to zero. Release the switch and turn the ignition off, and it will be re-set for another 7,500 miles.