Code 42 is : Electronic Spark Timing Curcuit (EST), Direct Ignition System (DIS) fault- bypass curcuit open or shorted to ground or, Fuel cutoff relay curcuit open- or shorted to ground. I have the exact sam problem so If you find anything please post it. Thanks
On the bottom side of the steering column inside the car, roughly at the level where the top of the seat is
I don't think so, because a 93 is an OBD I computer, the 98 is an OBD II
The P1406 code on a 1996 Oldsmobile Cutlass Ciera 3.1 is the code for the EGR pintle position circuit. I know this because it was my question initially and we bought a code reader to check the problem. It is a factory specific code, so the answer is quite specific. Good luck !
OBD I code 67 - Neutral Drive Switch Circuit Open ( key on , engine off )
No, it is obd 1.No, it is obd 1.
If Pin "B" is not present in the 12-pin connector, use the Actron SUPER AutoScanner CP9145 with a GM ALDL Cable CP9127 or use the Actron SUPER AutoScanner Kit CP9150. Either one will work on that OBD 1.5 system.
What does obd code P0740 mean
No OBD II only reads 96 models to current
problem with the coolant sensor check the connection on the sensor reset your OBD I code if that don't work replace the coolant sensor
A 1991 Dakota would have an OBD-I connector. It is on the passenger side of the firewall. It is roughly square on the outside.A 1991 Dakota would have an OBD-I connector. It is on the passenger side of the firewall. It is roughly square on the outside.
Obd1, obd2 wasn't until 1996.
A 1991 Dakota would have an OBD-I connector. It is on the passenger side of the firewall. It is roughly square on the outside.