0
On the bottom side of the steering column inside the car, roughly at the level where the top of the seat is
Wiki User
∙ 14y ago
Anonymous
Obd connector location on 95 ciera
Add your answer:
Earn +20 pts
How do you remove Headlight assembly on 95 Olds Cutlass Ciera?
The headlight assembly on a 95 Olds Cutlass Ciera is removed by disconnecting the wiring harness and removing the bulb. The assembly can then be unbolted and removed from the vehicle.
Your ac unit is not working on your 95 olds cutlass ciera s?
your switch that controls the compresser might be bad.
Where is the obdii port on a Buick Riviera?
The OBD port on a 95-99 Buick Riviera is directly underneath the steering wheel kick panel, look for a small sliding door up under the dash. One odd thing about the '95 riviera is that while the plug for the reader is an OBD II form, the computer is actually only OBD I compatible, it has come to be known as an OBD 1.5. 96-99 are all fully OBD II.
How much engine oil does a 95 Olds Ciera 3.1 engine hold?
4.5 Quarts. With oil filter. 4 quarts without.
Where is diagnostic plug for 95 olds 88 royal?
OBD plugs on a GM vehicle are generally under the dashboard, adjacent to the steering column.
Where is the obd II port located in a 95 Toyota pickup?
It depends if you really have a 95 toyota pickup or if you really have a 95.5 tacoma A 95 pickup is obd1 as obd2 started in 96 (or 95.5 on tacomas)
Does 95 BMW 325i have obd 1 or obd 2?
obd 2
Does a 95 cutlass ciera have a timing belt?
Yes
Where is the horn relay located on a 95 olds cutlas ciera?
The 1995 Oldsmobile Cutlass horn relay switch can be found on the firewall in the engine compartment. The horn relay switch will be on the drivers side of the firewall.
How do you replace a center stop light on a 95 Olds Cutlass Ciera?
I think the only way to get to it is to go inside the trunk. You will see the wires going up to it. Then after you losen it then you go back in side the car to change it.
What sensors are needed to be changed out from 95 ciera model three one L v6 engine to match back the original 95 supreme three one L v6 engine so the original engine harness fits the ciera engine?
Sensors needed to be changed out from 95 ciera model three one L V6 engine to match back the original 95 supereme three L6 engine are Ciera Knock Sensor and Soeedometer Sensor.
Can you use an obd-2 reader on a 95 Dakota?
No, the 1995 Dakota is obd 1. OBD-2 didn't start until '96 for most vehicles.
