with adequate plugs/wires, could be bad coil or ignition control module. Also check to make sure fuel is reaching the rail or fuel relay/pump(should hear run for a few seconds after turning key on).
No, the door on a 1998 Ford Explorer will not fit a 1992 Ford Explorer.
How do you replace evaporator on a 1992 ford explorer?"
My Haynes repair manual shows the firing order for a Ford 4.0 L OHV engine as 1-4-2-5-3-6
What causes back firing on a ford explorer and it to idle rough and want to cut out when you try to give it gas.
On a 1992 Ford Explorer : The coil pack towers are numbered : coil-----3 - 4 pack----2 - 6 plug-----1 - 5 ------------------------------------------------------------------------------------------------- The spark plug firing order is ( 1 - 4 - 2 - 5 - 3 - 6 ) -------------------------------------------------------------------------------------------------- The engine cylinder locations are numbered : firewall 3 - 6 2 - 5 1 - 4 front of Ford Explorer ( V6 )
Type your answer here... How do you remove ignition switch from 1992 ford explorer?
The 1992 Ford Explorer uses an A4LD automatic transmission
On a 1992 Ford Explorer : The firewall is the metal wall that divides the engine compartment from the passenger compartment
On a 1992 Ford Explorer : The voltage regulator is mounted on the back of the alternator
momogravel69@hotmail.com
I believe the 1992 Ford Explorer 4 door holds 19.3 U.S. gallons
ox on 1992 ford explore