Want this question answered?
HOW TO REPLACE A TIMING BELT ON A 1992 ACURA VIGOR? how do you change a timing belt on a 1992 acura vigor 2.5l how do you change a timing belt on a 1992 acura vigor 2.5l -------------------------------- See article at the Acura Vigor Club -- Related Links (below).
It is on the drivers side of the motor directly below the throttle body and air intake and is positioned behind the alternater.
On the acura legend you have to lift up the motor or lower it down and the transmission to change the mounts,.,,keep in mind on the front supports you can see them just below the radiator and you have to pull that out as well
The Acura logo features hallmarks such as a stylized character which can be read as either an 'A' standing for Acura or an 'H' standing for Honda. The word 'ACURA' is featured below the logo.
There is a pointer on the front engine cover. There are two notches on the crankshaft pulley. The white notch is Top Dead Center. The red notch is 15 degrees before Top Dead Center. To check the timing, first, jumper the Service Check Connector under the carpet on the passenger side footwell. Then, use a timing light and see if the red notch aligns with pointer while the engine is at 700rpm. If you need yo adjust the timing (unlikely), you'll have to open the cover on the adjustment resistor. Turn the resistor clockwise to advance the timing (or counterclockwise to retard it). Remove the jumper from the Service Check Connector when you're finished. There are photos, illustrations, and a more detailed description in the Acura Vigor Club's Timely Topics Archive -- see Related Links (below).
The thermostat is located just below the htrottle linkage at the throttle body. Follow lower radiator hose to engine. It is in the housing at the end of hose.
actually needed more info so im gonna assume its turbo if not then its this one below
The thermostat on a 95 acura integra ls is located on the left back side of the engine. below the intake. You will see a sensor plug-ed into it. The thermostat has 2 ten mill bolts holding it together and they are a pain. The best tool for the job is a ratchet wrench.
In the 1999 Acura 3.5RL, you pull out the cigarette ash tray in the console, it is below it, covered by a rubber flap.
See link below
Front of the engine, below the intake.Front of the engine, below the intake.
Click on the link below for more information.