This is for a four cylinder (most were) Torque sequence ------------ front | 8 4 1 5 9 | of | | engine | 7 3 2 6 10 | ------------ Step 1: torque long bolts 8,4,1,5, & 9 to 46 Ft/Lbs torque short bolts 7,3,2,6, & 10 to 43 Ft/Lbs Step 2: torque all bolts an additional 90 degrees Recheck final torque in sequence *** CAUTION *** engine uses Torque To Yield head bolts (TTY) that permanently stretch during the initial installation. New head bolts must be used when cylinder head is replaced or re-installed to obtain proper torque. This is for a six cylinder (One side at a time) Note: Torque sequence --------- | 6 2 3 7 | | 5 1 4 8 | --------- Step 1: torque in sequence to 33 Ft/Lbs Step 2: turn an additional 90 degrees Recheck final torque in sequence *** CAUTION *** engine uses Torque To Yield head bolts (TTY) that permanently stretch during the initial installation. New head bolts must be used when cylinder head is replaced or re-installed to obtain proper torque. This is all pasted from Auto Zone's website. It's not really copyrighted I'm guessing because you can easily go into a store and they will print this off for you. Good Luck!!
A 1993 Pontiac Sunbird head bolt torque sequence recommends starting at one and of the head and alternating to the other end of the head. You should end up in the middle.
head bolt sequence Toyota tercel
what is the head bolt sequence for 3.1L 98 Monte Carlo?
Purchase a repair manual at most parts stores, ( around $12 ) for detailed instructions on this and many other repairs.
you better get a chiltons book to get the torques and sequence
cylender head bolt torque for 1993 Mitsubishi expo
5 3 2 87 1 4 6 3.1 cylinder head bolt sequence
No such thing, just remove them. However there is a sequence to tightening them.
The 1996 Chevrolet Cavalier 2.2 liter engine had bolt torque specifications are 120 pounds. The head bolts should be torqued at 40 pound intervals.
I need head bolt torque specs and sequence on 2003 Chevy Malibu 3.1
The 1994 Nissan Pathfinder had bolt torque specification is 140 pounds. There is not any removal sequence. There is only a sequence to put the bolts in.
The Honda had bolt tightening sequence begins with the head bolts on each end of the head. Tighten the head bolts moving to the center, alternating from and to end.