answersLogoWhite

0


Best Answer

Working on 1993 Olds Cutlass Ciera 'S' right now with the exact same situation! Basically, the usual problem here is that the P/S pump driveshaft seal is what fails so you have P/S fluid leaking out there. The easiest solution is to replace the P/S pump with a re-built one, but in my case I have already taken the pump off, and removed the pulley from it because my plan is to just replace the pump driveshaft seal since I know that the pump itself is fine because it worked perfectly prior to the leaking problem, and I am incredibly cheap! Because replacing only the driveshaft seal requires a higher level of skill, this may not be for the average do-it-youselfer so in that case replacing the entire pump would definitely be much easier but you'll probably still have to remove the pulley from the old pump, and then re-install it on the replacement pump. A puller is required to remove the pulley, and a simple installation tool will put it on the new pump! This is really not that difficult if you have these tools, which can be rented for a few dollars at some large auto parts stores. A little experience is also helpful. To me, this is not really that difficult a job, but then I've been doing my own work on cars since I was about 15, which is about 30 years. Be sure to clean everything so as to remove all P/S fluid from all pulleys and belts, and also be sure use the appropriate new P/S fluid for this vehicle when filling the reservoir to the proper cold level, and do not over-tighten belts! Thanks

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1994 Oldsmobile Cutlass Supreme power steering pump is whining badly fluid partially slightly aerated foamy and overflowing out of the blue. Was fine last night when driven. Pump bad Suggestion?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is another word for slightly damaged?

partially damaged


What is the definition of a partially movable joint?

A slightly moveable joint is a fixed bone that can only move a little or slightly.


How much does a Oldsmobile weigh in tons?

Slightly less than 2 tons.


Where is the location of the idle control valve on a 1995 Oldsmobile Aurora?

Right in front of and slightly to the side of Throttle body


How does glucose help to recover a patient?

The glucose can be used as electrolites to partially share enrgy for a snap-needed patient AND SLIGHTLY ON THE RECOVERY POSSIBILITY.


Can puberty begin if a person is overweight?

Yes! In fact in females it is partially determined by body fat so slightly overweight girls may get it younger.


Is sand soluble in alcohol?

Rubbing alcohol will not completely dissolve sand, only partially. It is slightly soluble due to rubbing alcohol containing some water.


1997 oldsmobile dome light stays on?

should be on the headlight control, probably turned too far to left, turn slightly right and light should go off


Do Jews call Hanukkah by that name?

Hanukkah is a Hebrew word, and that is how we call it. The "H" in "Hanukkah" is a slightly rasping sound, formed by partially constricting the soft palate.See also:More about Hanukkah


How do you knock on wood when you dont have any wood?

you don't! You tap your skull just above an ear. It a slightly humourous suggestion that you are a block head - but then some people actually take it more seriously than that.


Where is the dipstick on a 1999 Oldsmobile Cutlass engine model 3100?

It's right in front and center. It has a yellow circular handle, and is just to the right and slightly in front of the oil cap when you open the hood.


Why does 93 Oldsmobile Cutlass make loud moaning noise in reverse only and you can feel vibration in steering wheel but it stops when brakes are slightly applied?

When a 1993 Oldsmobile Cutlass makes a loud, moaning noise in reverse it is possible that the reverse gear in the transmission is getting ready to go out. The braking system should be looked at too, because of the vibration.