answersLogoWhite

0


Best Answer

where are the two bolts located on the starter?

User Avatar

Wiki User

14y ago
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: 1994 custom buick lesabre starter bolts unreachable how to raise engine to remove starter?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the starter for a 1993 LeSabre?

Look at the lower rear end of the engine


Where is the starter on a 1989 Buick Lesabre?

The starter on a 1989 Buick LeSabre can be found on the driver's side of the engine. It is down low, back by the bell housing for the transmission.


What is the engine size for a 92 Buick lesabre custom?

3800 v-6


Where is the starter located on a 1989 Buick LeSabre?

The starter on a 1989 Buick LeSabre can be found on the driver's side of the engine. It is down low, back by the bell housing for the transmission.


Where is the starter located on a 1993 Buick Lesabre?

under the front of the engine about center of the engine. hope this helps


Can you replace a starter engine on a softail custom 2007 with a softail 2006 starter engine?

probably. If they are both OEM, they are interchangeable


Where do you connect the negative cable when jump starting a 2002 buick lesabre custom?

Ground on the engine block.


Where is the starter on a 1993 Buick lesabre with a 3.8 engine?

By the flywheel flexplate bottom of engine, follow batt cable (pos) to the end.


Where is the bolt to change the starter out of a 1987 Buick LeSabre 3.8?

There are 2 bolts that hold it to the rear of the engine.


Where is the fuel switch on 2000 buick lesabre custom?

fuel pump relay for you car, is located in the engine compartment fue box


How do you replace a starter on 1999 Buick LeSabre and where is it located?

Should be located at the rear lower section of the engine Remove the - battery cable Raise and support vehicle Disconnect the wiring at the top of starter Remove mounting bolts Remove starter


I have a 02 buick LeSabre custom when the key is turned to the run position all power and fuel to the engine is cut Had the starter tested works fine could it be the built in securety system?

Check your battery cables. Some computerized vehicles have to be reset. Disconnect the battery for about 5 minutes and then reconnect.