answersLogoWhite

0


Best Answer

U-Joints probably

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1994 ford thunderbird when you get on the gas and let off theres a cluncking noise in the rearend what is that?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

92 chevy4wd clunking noise in rear?

probably your rearend


You hear a thumping or cluncking noise every you tap on the brakes lighly or hit a pothole or shift gears?

Bad Ball Joint


1997 Nissan pickup cluncking in the steering wheel when turning?

first check power steering fluid,if to low then air is inside causing noise or p.s. pump is bad.


My 1996 ford thunderbird lx makes a lot of noise underneath like everything under there is loose and it also feels like theres no shocks?

is it from the front end if it is then check your struts or the stablizer linkage that will make alot of noise, its easy to check the stabilizer linkage just grab the bar and move it, they are also a cheap part to replace.


What are possible causes of a cluncking noise Chrysler Town and Country 2002?

control arm bushings need to be replaced. It may also be a cat is in the engine compartment they like to sleep there at night to stay warm Dont laugh i have seen it happen.


What is the sign of a solenoid going out?

theres a clicking noise then nothing happends


Cluncking noise while turning at any speed mainly at corners this is for a Nissan micro r plate this sound is coming from the tire side a friend told me its might be the wish bones could this be true?

that sounds like your cv joint is gone


What causes a Toyota camery to make a loud cluncking noise the front end of an automoblie to shake with little control of the streering?

Clunking when you hit a bump? Push down on the front and release. If it clunks then, it's a strut. Do each corner and you can tell which side it's on, but both should be replaced


Do dogs know if something is inside the wall?

Only if theres a small, but loud enough noise.


What would cause a sort of rubbing noise like low brake pads on the rearend of a 1998 Chevy S10 after replacing both bearings?

Low brake pads, misassembled brake parts?


Noise pollution in your locality?

if there is noise pollution, shut yours, and listen to music, mate, cause i doubt theres anything that u can do about the noisy cities nowadays.


Loud clicking noise when you brake under 10mph?

chekyour tire screws, am sure theres the problem