answersLogoWhite

0


Best Answer

check the cranckshaft sensor and alarm system

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1994 jeep grand Cherokee wont start. If you let it sit for 30 sec to 5 min it will then start and run fine. I have no injector pulse or fuel pressure when its in no start mode.replaced fuel.no change.?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change spider injector in 2000 S-10 4.3?

Removing the upper intake manifold will gain access to the "spider". It is not necessary to replace the complete "spider" if there is only one bad injector. Each injector and the pressure regulator are replaceable.


How do you change injectors on a powerstroke 6.0?

To change the injectors on a 6.0 you must first 1. Remove the valve covers 2. Remove the high pressure oil rail. Be careful not to drop any bolts, not to break off the injector connectors, they break easily. 3. Remove the injector clips on the outside of the head, inboard towards the turbo. 4. unbolt the injector 5. Use an injector puller so that you dont damage the injector, or injector bore.


How do you change a fuel injector on a 1988 Toyota Camry?

How do you change a fuel injector on a 1988 Toyota Camry


Why is there white smoke coming out of your tractor?

Could be an injector spraying at below the pressure that it should. Or a head gasket. Check your radiator for milky fluid, if not you can determine the bad injector by loosening the nut at the injector line/injector until the sound of the engine changes. The one that does the least change to sound/rpms is the bad one. You can have it tested at your local dealership.


How do you change a fuel injector in a 1987 Nissan maxima?

Where is the fuel injector located?


How do you change a 1997 Chevy 4.3 injector?

can i change 1 fuel injector on 4.3 6 cylinder silverado 2003.


How hard is it to change a fuel injector in a 1999 ford crown Victoria?

Depends on your level of mechanical expertise. You must remove the entire fuel rail to change one injector. It's not hard for an experienced mechanic but a novice might have a difficult time. Please note this is the delivery system for engine fuel (gasoline) under pressure. Caution to insure there are no leaks after the injector is replaced is required.


What is a fuel pulsation damper on a Toyota?

Fuel pumps can produce a pressure drop and rise as variables of voltage and temperature change a dampener absorbs this rise and fall of pressure and keeps the pressure closer to a constant flow for better injector operation.


How do you change fuel injector c12 cat?

procedure to RR fuel injector c12 cat


On a 1996 Chevrolet Caprice how to know whether to change the fuel injector of the fuel pump?

There should be a fuel pressure "test" port behind the throttle body. Test the fuel pressure at the test port using a fuel pressure gauge. If the engine starts using starting fluid and doesn't start without, and the fuel pressure at the test port is normal... you have something else going on. It COULD be the injector, but don't assume until you've tested other stuff.


Why is your 96 Jeep Cherokee pushing oil out of the oil pressure sensor?

Its the oil sending unit - get a new one they are only like $10 and easy to change.


How do you change fuel injector on dodge v6?

matters where the leak is at