0
1994 prism with no spark you have installed anew distributor and still nospark at plugs?
Wiki User
∙ 16y ago
Coil?
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is the gapping 1999 Chevy prism spark plugs?
1.1 mm
Where are spark plugs located at on motor of 1994 geo prism?
if you can't find the plugs you have know business working on this car.
Visible light from a distant star can be spread into a spectrum by using what?
spectrometer which has prism installed in it
What are possible causes of the check engine light indicatesing a misfire in 3rd cylinder on a 1999 Chevy Prism?
I have a 2001 Prism, and all i did was replace the spark plugs, and reset the battery it went away....
Does the distributor on a 1994 Geo Prism have points?
The distributor on a 1994 Geo Prizm does not have points. It's got an electronic ignition system. The ignition coil and module are located inside the distributor. If you're doing any testing of the distributor, be sure to replace the spark plug wires first. Defective spark plug wires will instantly burn out the coil and in some cases, the module too.
Why would a Geo Prism that has a new coil put on it suddenly start missing really bad while driving?
Bad plugs or plug wires.
You have no spark on 94 prism?
Check ignition coil primary and secondary resistance using an ohmmeter. Check for burned distributor rotor. Check for faulty igniter if so equipped. Also, for more answers try asking this question again but replace "prism" with "corolla."
What is the firing order on 1.6 Vin 6 Geo Prism 1990?
Firing order goes CCW on distributor, 1, 3, 4, 2. Number one cylinder is first one on the passengers side. Number one on the distributor cap is aprox at the 1 O'Clock position.
What is the spark plug gap for a 1995 Geo Prism LSI. NGK recommends .043 but car stalls when put it in drive. Old plugs were set at .035 What should be done?
1. Check the NGK spark plugs you got to make sure they are the correct ones for the application. If you got the standard (non-platinum) plugs, they should be BKR5ES11 or BKR5EYA11. 2. Double check to make sure the plugs are gapped at .042". If you got the correct plugs, they are normally pre-gapped at .044". It's pretty close to the actual recommendation of .042", but just to be sure I'd take them out to check, because if they are set at .044" rather than .042", the gap would be a bit too wide and could be a possible cause of stalling. 3. Make sure the plugs are all seated correctly, to the proper torque. 4. Make sure the spark plug wires are good and all firmly connected to the plugs and distributor cap. Be sure that no wires are accidentally "crossed". 5. Make sure no vacuum hoses accidentally came loose while you were doing the spark plug change job. 6. Are the distributor cap and rotor brand new? For the optimum tune-up, it's recommended that those (and the ignition wires) be replaced along with the spark plugs.
What is the name of a 6 edged prism?
There is no 6-edged prism. The simplest prism, a triangular prism, has 9 edges.There is no 6-edged prism. The simplest prism, a triangular prism, has 9 edges.There is no 6-edged prism. The simplest prism, a triangular prism, has 9 edges.There is no 6-edged prism. The simplest prism, a triangular prism, has 9 edges.
Is a hexagonal prism a prism?
Yes, a hexagonal prism is a type of prism.
How do you change the rpm idle rate on a 1998 Chevy Prism?
A 1998 Chevy Prism's idle speed is computer controlled. You will have to take it to a garage to get it set. However, the idle speed could be altered if, say, your spark plugs are seriously worn. Changing them may restore the original idle speed.
