0
Add your answer:
Earn +20 pts
Where is car stereo amp on a 1994 Lincoln town car?
The car stereo amp on a 1994 Lincoln town car Is in the trunk, right side behind the seat
Where do you find a stereo wiring diagram and the location of the amplifiers on a 1994 Chrysler Town and Country van with the Infinity stereo system?
The amplifiers are on the infinity speakers. Each speaker has its own amp.
Where is the infinity amp location in a 97 grand caravan?
The 1997 Grand Caravan Infinity amp can be located behind the stereo system. The stereo system will need to be removed in order to access the amp.
Where is the stereo amp on a 1994 ford explorer limited?
Behind the Passenger side rear back panel by the wheel-well
97 Ford Explorer stereo fuses?
On a 1997 Explorer, in location # 20 of your fuse panel, there is a 7.5 amp fuse for the radio, and in location # 29 there is a 10 amp fuse for the audio system.I'm not sure if there also is a fuse on the back of your radio.
Where is the factory stereo amp located on a 2007 Cadillac CTS?
Where is factory stereo amp located on a 2007 Cadillac cts
How does a amp work?
A mono amp, is half of a stereo amp. It has one input and one output.
Location of the factory amp for 98 ford expedition?
If you pull the stereo and follow a big group of wires that run directly behind the stereo on the trans hump, you will find it. It is just forward and below the stereo. Not sure of the easy way to get to it as mine was already bypassed.
How is a 1994 ford explorer amplifier wired?
when i hooked up my stereo it took me a while to figure out what those extra wires were lol but i ended up hooking the amp wires up to a ground coming from the stereo that worked.
How do you install an amp in a 1987 Grand Marquis?
Clarify....Are you talking about an AMP for a Stereo?
How does a mono amp work?
A mono amp, is half of a stereo amp. It has one input and one output.
How do you put an amp and subwoofer in an 1996 Chevrolet pickup?
if you have aftermarket stereo it is very easy pull the stereo out of the dash and take your rca wires and plug them in to the back of the stereo and then take your blue wire which is remote wire and conect it to the remote wire on the back of the stereo, from there you rum the wires to your amp. ground the amp and hook up the sub to the amp and you are good to go. hope this helps.
