Fuses That "Blow" Repeatedly
Without being able to "hands on" troubleshoot the circuit served by the repeatedly blowing fuse, no one can identify the specific cause/defect which is causing your problem.
The following generic answer applies to any electrical circuit, whether in a vehicle, or in a building, or whether alternating current [AC] or direct current [DC].
Fuses [and Circuit Breakers] are safety devices designed and installed in electrical circuits TO PROTECT the conductors [wires] and other components from short circuit conditions and/or overload conditions which cause an extremely large flow of electrical current [measured in Amperes], which causes overheating of the conductors that results in damage to the insulation and the conductors. And in a worst case, the probability of a FIRE which could destroy the vehicle, house, or other structure in which the circuit is located.
When a fuse or Circuit Breaker [and replacement fuses, or "tripping" Circuit Breakers] "blow," especially if it happens repeatedly, is an indication of an UNSAFE CONDITION in that circuit, usually a short.
The fuse or circuit breaker is doing what it was designed, intended, and installed to do, protect the conductors and components of the circuit which it serves.
The proper "fix" is for a qualified technician, who knows what he or she is doing, to troubleshoot the involved circuit, find and identify the defect, and make proper repair [s], BEFORE replacing the fuse again [with the properly sized fuse or before resetting a circuit breaker].
Some ignorant few will suggest installing a larger fuse or breaker to solve the problem, BUT that will only increase the hazard, not correct it. Do not follow "bad" advice by installing a larger fuse in a misguided attempt to correct the problem. To install an over-sized fuse would almost guarantee damage to the wiring and an electrical system fire.
A fuse that keeps blowing is an indication of a malfunctioning ignition. The ignition may be the culprit or the wiring leading to the ignition may be the problem.
the starter has failed.
Very doubtful that an oxygen sensor would do that.
You may have a problem in the pump. Take it off and check .
There is a problem with the Electronic Traction Control (ETC)
M o st likely cause is a restricted catalytic converter.
There are a couple of reasons why a headlight keeps blowing on a 2001 HyundaiÊ Elantra. There could be a problem with the ground circuit or the connector.
change MAP sensor
I am having the same problem, Have you had any luck finding out what it is
Say when you turn with Trac off your motor increases and decreases power from one front wheel to another. With Trac on your motor keeps an equal amount of power to each wheel.
my Chevy cobalt 2005 keeps blowing the fuse everytime i put my windows up or down i had the door wireing replace a new window motor replaced new switch and it still blows the fuse what can the problem be
A corroded ground wire will cause a fuse to blow. Until the ground wire is cleaned the problem will persist.