Last time I looked it was on the bottom of the oil pan.
1998 Chrysler concord 2.7 just ran for 20 minute's - bs.
On some Chrysler radios there are two round holes on the display panel of the radio with a letter h and m for hours and minutes. just take pen point and push into these holes to set the time.
with the radio off use the seek buton to set the time
Jeep is part of Chrysler, which was part of Diamler Chrysler at that time.Jeep is part of Chrysler, which was part of Diamler Chrysler at that time.
I have just bought one on Ebay for $75, there was 8 left in stock at the time.
You remove them one at a time, and install the new one the same way.
you have a short inside your radio.
Time for a new car ! Not a Chrysler product !
1995 and before, you pull out the top. 1996 and later the engine and transmission come out the bottom at the same time.
Boston is 70 mi. from Concord Time: Approx. 1 hour, 14 min.
with car on Press 1 and 6 at the same time, turn the radio on, then enter the 8 digit Serial Number exactly as it apears on the display.
Turn on radio, Push volume button till the time mode appears. Then push small set button normally on the right side of the radio. Push Scan button to advance hours and seek button to advance minutes.
On the right side of the display there are tow little holes labled H and M for hour and minute. Turn the radio on and when you have the time use a papre clip or something similar , and push in the hole to set time.
2004 Chrysler Concord headlight bulb replacement: Purchase the correct replacement bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Check for a loose wire or loose fuse
The 1992 Chrysler came with a couple of different radio systems -- the standard radio with cassette, the standard radio with cassette and graphic equalizer, the Infiniti I premium radio (with just cassette player), and the Infinity II premium radio (with both cassette player and graphic equalizer). The following instructions should enable you to set the time on any of these systems: To start the procedure, the radio display must be showing the time. If the radio frequency is being displayed, press the SEL button to activate the time display. 1. Press the SET button and "P" will be displayed. 2. Press the SEL button or Time Program control (on units with a graphic equalizer) and the hour will be displayed. 3. Rotate the tuning knob or push the tuning button up or down to change the hour setting. 4. Press the SEL button or Time Program control again to display minutes. 5. Rotate the tuning knob or push the tuning button up or down to change the minutes setting. 6. Press the SEL button or Time Program control one last time to complete the procedure.
whats a radio
I have had this exact problem. In my case, it was the antenna connector on the radio itself. It needs to be resoldered on the radio and then it will work just fine. - RL
7:00 am Ascension Island is at GMT+0 and Concord, Mass is at GMT-5
38 seconds in a concord jet.
SOME OF THEM U HOLD THE ON/OFF BUTTON IN THEN PRESS THE PLUS OR MINUS SWITCH-FOR THE CHANNEL.
if it is a manual... rev it up to 6k and pop the clutch. that audda do the trick! happens to me every time! lol
There is no such thing as a 1998 Chrysler Fifth Avenue
The easiest way is to pull every fuse out one a time and check it ( see if it has blown ) replacing it if it blown or reinstalling it if its ok. go look