1996 VW jetta wont start after installing a CD player but engine will turn over two wires touched and sparked what could be the problem?
If two wires touched and sparked, more than likely a fuse was blown. Check the fuse block for the blown fuse and replace it.
You were setting up a deck in your VW 1996 Golf CL and two wires touched and sparked and now the car won't start what happened?
You have probably blown a fuseable link, look at the big fuses in the engine compartment fuse panel
Where is the ground wire on your starter to your Dodge truck I tried to tighten the starter and I accidentally touched the ratchet to the manifold and it sparked does that mean starter not grounded we?
Most starters are grounded through their mounting bolts and contact with the engine. Some starters have a braided ground cable between the starter and engine or frame. The arcing occurred because you shorted between an electrically "hot" connection and ground , i.e. the manifold.
i don't think so. i would recommend to Google it: moviestarplanet cheats without installing the cheat engine
Need to know what type of engine and year.
Depends on engine and manufacturer.
The LS3 engine was offered to three different types of vehicles, the Pontiac GTO, Chevrolet Corvette and the Chevrolet SSR. About 1998 is when they started installing these motors.
I wasnt aware Chevy used a 400cc engine
Installing a 5.8 Triton engine on a expedition do you have to lift up the body to get the engine in?
Ihave a question 1996 Oldsmobile achieva sl v6 engine 3.1 you had a friend mixed wires you are trying to fix it seems have no photo in hanes book repairs have any pictures that will help?
Had a similar problem while installing an engine I didn't remove. Go to the junk yard and take lots of pictures.
If the engine is diesel, no that is normal. If the engine is gasoline, yes it is probably burning oil.
I tried to install a CD player in my 1999 mercury cougar. It has a 2.5 liter vg engine. Two wires from the car touched while installing the radio and the wires created a spark. Now my car wont start.?
Start by checking all of the fuses in the fuse block. There is a good chance that one of them has blown.
use your eyes and brain,
Is it a big problem to have noisy tappets in your engine?
The first reliable steam engine by Joseph Watt in 1775. It was able to convert steam into useful mechanical power.
Most likely means an engine that has not been worked on or touched with any new parts, probably remains in it's original condition.
The cost takes into account the price for a new or used engine and the service charges. Used engine can be $1,250. Installing the engine can range between $262 - $574.
You own a 1990 Chevy Celebrity that ran great then you had the battery changed and the person changing the battery sparked it and then the car immediately started stalling out?
The engine control module "learns" the particular operating characteristics of the particular engine in the car. When there is no power to the engine control module, as in when the battery terminal was disconnected, the memory is often "lost" and upon reconnection has to be "re learned" If that is the problem your car has it should be able to learn again, simply drive the car around at moderate speeds for a time.
Why do American car manufacturers favor large displacement naturally aspirated engines over small forced induction engines?
In short, YES. If the auto manufacturers began installing turbo chargers on every car then prices would go up. Consumers hate that. The buyer is the one who must pay for the extra fuel un a larger naturally aspired engine vs. a smaller turbo charged engine. That's not the manufacturer's problem, it's the buyer's problem.
If you are installing the engine in an exact model that the engine is coming out of, the harness should not be needed. If there are any changes in model, sensors or anything else then the harnesses will not be interchangeable.
There is a problem with the emissions system. Need to have engine scaned with a engine scanner, and it will tell you were the problem is and whats going on.
no, installing a new engine will not reset the odometer, it's against the law to reset odometers.
He was asked to take a "look at" a Newcomen engine to repair it if he could. This is what sparked his interest in improving steam engines.
They are both GM products why would you?
You will have to get a engine scanner and scan the engine. And it will give you the trouble code or codes, and then fix the problem. The computor is seeing a problem in the engine system or transmission system. Need to repair.
Not a problem unless you plan on running the engine... Of course it is a problem. An oil filter is mandatory for the life of the engine.
The check engine light comes on in a car when there is a problem with the engine. It will go off or be reset when the problem is fixed.
A thermostat always goes in spring side toward the engine.
This is much too complex for WikiAnswers. It could take an entire website by itself.
This might not help... Get a new one.
I have had the experience of installing CNG kit in my Toyota Corolla GLi 2010. I got the kit installed in July and after a few days, I started facing problems. Sometimes, the engine stalled ... It was embarrassing The kit was installed by Toyota Motors. I took the car for check up. The replaced the emulator and so far there has been no problem. Of course, the CNG as a fuel is less powerful… Read More
Any size SBC engine will fit and is compatible with a 91 Firebird. A 350 engine is the most common that is used for installing in a 91 Firebird.
If you have a 2003 Chevrolet impala 3.4 engine blown head gasket can you replace engine and it will solve the problem?
It will solve the problem. The 3.4 is notorious for poor head gaskets. You can replace the gaskets on the engine without replacing the engine, and that will solve the problem for quite a while. It will be much less costly than an engine replacement.
Disconnect the negative battery connection for a few minutes then reconnect. That will clear the existing codes but it is not necessary to do because if the problem has been fixed and does not reoccur after several drive cycles, the ECM will turn the check engine light off.
What could be tha problem when a check engine light comes on in a 1999 mercury tracer Engine does not seem to have any problems?
Check the engine. ===================================================== There is a problem with something that effects the emissions of the engine You need to have the vehicle scanned for any trouble codes to help diagnose and then repair the problem
How do you bypass alarm system in sebring 2004 Alarm was going off when anything touched car and would not let me start the engine?
First of all it's a Sebring... place dynamite under the car. Make sure not to touch it (the car I mean)! Then blow up dynamite and well problem solved.
When service engine light is on on a 2003 Chevy Trailblazer, the problem could be a faulty thermostat, a circuit range performance problem, or any other problem.
The engine could possibly seize.
If you are referring to the Check Engine Light, then there is a problem with the emissions system. Have it looked at by a professional with the tools and knowledge to diagnose the problem.
Warning lights come on when there is a problem. An Engine management light comes on when there is a problem within the engine, that may cause problems later.
your problem is the rocker/engine cover is blocked the only way to fix the problem is to change the rocker/engine cover.
There is a problem with the emmission system are transmission and the computer turns the engine light on to let you know there's a problem. Have engine scanned with a OBDII engine scanner.
Have vehicle scanned to determine the problem
I have Toyota 2l-T engine the problem is the oil blowing on the exhaust is this the turbo charger problem?
Code PO420 is catalytic converter efficiency low bank 1, sensor1. You did not state as to the year,make and model of the car as well as the engine size. I am a member of IATN and the majority of there fixes was related to someone installing an AFTER MARKET converter. There is a big difference. I strongly suggest that you go to a repair shop with the proper equipment as well as a very good… Read More
If this occurs, then it means that there is a problem with you engine. A mechanic can figure out how your engine should be fixed.
That means there is a problem in the emissions system are the transmission and other places too. You need to have the engine scanned with an engine scanner to see were your problem is.
There was no problem.
I do not have a answer for it, do you an answer for this problem?
No. But if the pump is driven by the timing belt, it is good practice to replace the pump at the time of installing the engine. A pump failure will cause the timing belt to jump. In the majority of cases this will cause valve to piston contact. Plus, if the part is hard to change, maybe you should do it now rather than later, when it will be much harder to get to.
the engine light stays on. Hyundai dealer wants 241 plus to install and fix. Does using car with engine light on do damage?