0
1996 ford ranger you turn key and engine turns over then immediately stalls and won't run is that the fuel pump?
Wiki User
∙ 14y ago
It sounds like what is called the cold start solenoid going bad
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
When 97 Geo Metro Engine cranks and turns over then immediately stalls When tried again it just cranks?
fuel filter... or throttle body
What are the sings of a 2002 crown Victoria fuel pump is going bad?
Well, one sign would be that the engine turns but does not fire, or engine stalls here and there.
Sentra stalls making turns?
If a Nissan Sentra stalls when making turns, check the fuel and spark. The coil may be cutting out when it gets hot.
Mercedes s500 turns over but does not fire?
Could be faulty ignition coils especially if engine starts when cold then stalls and will not start once warmed up.
What is wrong with a car that will turn on but then turns off immediately?
chances are the battery is out of wack or the engine could be flooded
98 ford 150 engine bucks then stalls when in gear OD light blinks?
Turns out it's the vehicle speed sensor (vss) located near rear of transmission
What causes a car to jump and cut off when your at a stop light?
when your in a manual and you have the car in first gear with the clutch all out the wheels cannot move and so the engine cannot work or it will break so the car stalls and the engine turns off
Engine stalls after warm up. code 36 apears on scan tool also cooling fans both run instantly it starts again immediately then check engine light turns on. ecmdist stunning. its a 93 z28 code P?
OBD1 code 36 is a high res failure. Due to a bad or failing optispark distributor. My 95 has this same code and still runs but the optispark is not sending a signal to the pcm. If I crank the engine for about 7 seconds it will start every time.
Why does a Nissan Altima 2005 suddenly stalls then turns back on?
Have the Ecm re-programmed for free at dealership
Distributor 89 ford ranger distributor firing order?
1 - 4 - 2 - 5 - 3 - 6 The distributor rotor turns CLOCKWISE ( on the 2.9 L - V6 engine )
Turning off check engine light on 1993 ford ranger?
Try disconnecting the battery for 10 minutes or so. Reconnect it and then start the vehicle and see if the light turns off.
Why might a car stall shortly after the oil and battery light came on and not start again?
It could be the alternater.AnswerSome cars have a safety switch that shuts the engine off when the oilpressure is to low, but if those lights came on when the car stalled it might be because the lights on the instrument panel that turns on when you start the car usually turns on when it stalls.
