answersLogoWhite
Headlights Tail and Brake Lights
Ford Expedition Eddie Bauer
Ford Explorer XLT

1997 Explorer XLT how do you replace the rear middle tail light in the rear hatch?

424344

Top Answer
User Avatar
Wiki User
Answered 2006-04-14 21:32:25

First of all, it's not a "bulb" but a florescent tube and ballast assembly. To remove and replace, you must first remove the plastic covering on the inside of the rear hatch. Then it's just a matter of removing the 0ld and putting in the new.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


how do you replace the fog light bulb on a 2003 ford explorer.


replace head light switch on 93 ford explorer


How to replace a brake light on a nissan Tiida hatch back.


you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light. you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light.


To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.


Open the entire back hatch, and unscrew casing, and replace bulb. Now redo what you've undone.


You replace the hazard light fuse in a Ford Explorer in the fuse panel box. The fuse panel box is located under the vehicle's hood.


You will probably find it is a mercury switch in the wiring bundle.


Please, be more specific: WHICH interior (LOCATION) light bulb(s) are you trying to replace?


to replace the tail light open the hatch look on the side of the light you will see two screws remove them. Pull the light out, take the three bulb out ken


Raise the back hatch there is two screws that hold the tail light on (2002 ford explorer) remove the tail light and twist out bulb housing , pull release clips and remove bulb. Install bulb in reverse.


As far as I know the keypad has to be changed ( my 1995 Ford Explorer XLT keypad doesn't light up anymore , also )



How can i replace my middle brake light on my 2005 kia sorento.


Open hatch and remove strap and handle. Remove rear panel attached to hatch by popping off of hatch. Be careful because the clips are not strong. Use bulb 921 @ 18W.


Above the headlight there are 2 screws in a little circle. Remove those and then pull out on the light.


the light is an integrated part with the trim piece and must be ordered as such its operated by a ballast that can go bad and cant be tested if theres power to the ballast then you need the trim piece this all is according to another answer found on this site


On a 1989 Acura Integra hatch back the brake lights are reached through the hatch itself. The brake lights housing are on the rear of the vehicle. Unplug the bulbs and replace them.


Either check your alternator or your battery life and replace as see fit.


There are detailed instructions on the inside of the owners manual. You have to open the rear hatch and remove the screws on the light fixture.


you should be able to open the rear hatch and be able to see two screws on either side holding them in


raise the hatch pull down on the carpet, determine which light is out and twist to come out, you dont replace from the outside of the car!!!


The light switch is located above the hatch door ceiling.


The bulbs in the middle on my 94 Saturn went out one a time, you don't have to remove a cover, they are accessible by lifting the trunk lid. There are like 5 of them they just pop in and out.


open the hatch there are two screws remove them and the tail light will come out, after that there are three more screws remove them and you can get to the bulbs to replace them



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.