Bad fixtures? Bad ground? Bad sockets? maybe t connector for trailer hitch is bad?
I had this same problem with my 2003 Venture. The Cheverolet dealership told me that the cruise contol is directly linked to the brake lights. The simplest and cheapest place to start would be to check your brake lights...if they are not working, you will not have cruise control.
Have vehicle scanned to determine the problem
If the brake lights do not work on Chevy Venture van 2000, try to disconnect the brake switch. Then short the two contacts of the connector to check if the brake lights are now working.
My dashpanel lights stopped working in your Chevy Monte Carlo ss 2001 what could the problem be
If parking lights and dash lights are not working and fuse blows out, there might be a problem with battery corrosion. Check the components specific to the circuits of the affected lights. It might be loose.
Bad bulbs can be the cause of your reverse lights not working on your 1999 Toyota Tacoma. A problem with the reverse switch or bad wires can also be the cause of your reverse lights not working.
Bring to a shop that has an ABS scanner to determine the problem I had this exact problem. The problem was that the wheel cylinder was leaking and causing the TCS and ABS lights to come on. I replaced the rear drums and pads and wheel cylinder. This solved the problem.
There is likely a problem with either the headlight switch or the associated circuit.
If you call the dealership there is a recall on the rear tail lights. Something todo with the wiring in them..
Replace bulbs, check operation of door switches. Check position of dome light switch. Make sure light bulb contacts are clean.
it is most likely a fuse or at worst the turn signals and stop lights work through the turnsignal switch
In my venture ther is a switch on the overhead console that disables the inside lights.
The problem probably wasn't the bulb. The problem is the fuse is blown and needs to be replaced and the problem will be resolved.
signal lights not working.
If the motors are working, then there has to be a problem between the motors and the lights. If they are only "working" though if you bench test them, and they don't actually do anything when you turn on the lights, then there must be an electrical problem such as a break in a wire or a bad ground to the motors.
I have the same problem with my 1999. The tail lights as well as the interior instrument panel and the license plate lights are all not working.
I would suspect a ground problem. Saying that, check the brake light switch.
Hi, You didn't mention exactly what lights you are interested in, but I have included a link to the fuse boxes for the 2001 Venture. Good Luck, Greg
Have you checked the bulb?
Start with checking the fuses.
Check the brake light bulbs, Check the brake light fuse, Check the brake light switch, In that order.
Please re-phrase your question; it appears you are saying the brake lights come on when you push the brake pedal and the lights are working (normal operation). If the lights are staying on after you release the pedal, then the problem is with th brake light switch (sticking). Thanks Malcolm
If the engine isn't running, the battery is low. If the engine is running, the alternator probably has a problem. If you are wearing dark sunglasses, remove them and the lights will get brighter. good luck!