The computer does - there is no way to adjust it. If it is improper something is wrong with one of the sensors - that is the most likely problem.
Not very likely - the Windstar was significantly redesigned in 1999, and the dimensions of the vehicle were changed.
what the number of the fuse on window 95 windstar diver side
The 1999 Ford Windstar does not have a separate computer for the fuel system. The vehicle computer contains all of the functions for the fuel system. The vehicle system computer is located behind the kick plate.
In addition to the front core in the dash, if the van has the optional rear climate controls there will be a second one back there.See "Related Questions" below for lots more about Windstar heater cores and climate controls
The bulbs can be replaced for the radio and heater controls on a 2000 Windstar SE by removing the plate over the heater controls. Some models need an Allen wrench for this and some models will need a Star wrench to remove the screws holding this plate on.
my side doorlock not warking what i do
the same thing happens to mine........just turn the interior light switch of......it works
According to the 1999 Ford Windstar Owner Guide : " behind the access panel located on the right rear quarter panel interior trim "
To get you started with the dismantling, refer to the "Related Questions" below regarding removing door panels
Sounds like normal operations / behavior.
It should be the #10 fuse.See "Related Questions" below for more
It sounds as if there is a problem with the rear electronics module in the Ford Windstar. This controls the front and rear lights and it is located in the back in the cubby with the jack.
Your door lock actuator is faulty and needs to be replaced
Take it apart to determine the cause. Only then you will be able to fix it.
Turn the door switch located at the front of the overhead console to off.
To turn on the highbeams of a 1998 Ford Windstar, bring your lever that controls the wipers toward you and release that turns the highbeams on. To turn off highbeams just push the lever towards the dash.
Passenger side firewall underneath the plastic grill that is there. The plastic grill needs to be removed to get to the computer.
It's located behind the glove compartment in the light delay relay panel.
From the Owners Manuals:1995-1998 - Fuse #27 - Interior fusebox1999-2003 - Fuse #27 - Interior fuseboxSee "Related Questions" below for more
No - the computer will notice some better sensor readings all by itself
The headlamp switch on the windstar does not actually switch the lamps. It is a signal input to the instrument cluster computer. The cluster module actually controls all lights individually. It sounds as if there may be a problem in the instrument cluster. This could be a bad module or simply a corrupted program. It will probably need a mechanic with a diagnostic computer and the programming skills to understand what it is telling him / her. Carl
One thing that will cause this is when a door-ajar warning goes without fixing.My Windstar rear hatch showed as ajar for quite some time - after a period, this caused the interior lights to be disabled.Flooding the hatch latch mechanisms with spray lubricant, i.e., WD-40, cleared the false ajar warning, and the interior lights automatically starting working again.See "Related Questions" below for more
The overdrive in the Windstar could have an internal problem, or the control from the overdrive button may not work. Run a check of computer codes to see if a problem shows up.