0
1999 Ford Explorer Sport 4.0E V6 shakes and jerks randomly code P1150 P1151 and P1152 replaced intake gasket no vacuum leaks 65lbs fuel pressure O2 sensors good what could be the problem?
Wiki User
∙ 15y ago
i have same explorer and my shakes and jerks especially at a light.... what have you replaced on yours?
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
1999 ford explorer radio stays on when ignition is off?
I have the same year Explorer and my radio had the same problem... The problem was in the radio and it just needed to be replaced with a new one.
Why cant i put a aftermarket stereo in in a 1992 Ford Explorer?
who says you can't? I replaced the stereo myself on my 93 ford explorer with an aftermarket stereo with no problem.
The speedometer has stopped working the speed sensor and speedometer cluster has been replaced in the dash - What is the problem 1996 Ford Explorer?
May have replaced the wrong sensor or you have a bad wire in that curcuit. gm Jim
Renault megane II check gearbox?
Common problem have Solenoid replaced Usually the pressure regulator valve.
Where do you find out what a code number indicates on your 2002 explorer with regards to a transmission problem or a pressure control solenoid?
http://www.obd-codes.com/
Have replaced fuel pump the fuel pressure sensor and the fuel filter in your 1996 explorer am still having a problem with starting it soon after turning it off 10-20min If it sets for about 45 min it?
sounds like the battery is worn out when the engine is hot it takes more battery to start
What makes a motor shake shake when stopped at a light in a 1994 Ford Explorer?
could be a vacuum hose leak--had the same problem and once the hose was replaced it stopped.
Ford explorer sport trac third brake light works but others dont work?
I have the same problem - but my third brake light slightly flashes when the car is of (Explorer 1998). I have replaced the "stop light" switch with no improvement at all.
What do you do when the check fuel cap light comes on in my 2003 mercury mountaineer check?
I had the same problem on my 2002 Ford Explorer, after I replaced the gas cap the light turned off
Why would my oil pressure gauge on my 2002 corvette be readinfg at the highest level?
I have a 98 with the same problem. The sensor in the engine needs to be replaced.
If your 1996 ford windstar cranks but won't start what could be the problem?
I hear that the problem is the pressure to the fuel pump. Also have heard that the alternator is the problem. To be honest, I cannot figure out why mine will not start either. I have replaced the fuel filter, O2 sensors, thermostat, reset the inertia switch, and spark plugs and wires.... nothing has worked yet. I have had the same problem, 2cd Explorer. I replaced the fuel relay. No problems now
I replaced a 1991 Nissan 204sx slave cylinder. Now it will not build up pressure and the pedal stays to the floor. What is the problem?
You need to bleed the clutch
