0
What else can I help you with?
Your 1988 bronco 302 is getting spark and fuel but wont start you recently replaced the head gaskets what could be the problem I replaced the coil and it is getting good fuel flow and good spark?
You probably have a bad Electronic Control Module. They are notorious for going bad.
Emission control problem 1998 Jeep Grand Cherokee?
catlytic converter is plugged and needs replaced
Does the temp control need to be replaced in a 93 Cutlass Supreme when the air will only blow out the floor and a little at the windshield but not the vents?
the temp control is not the problem. the air direction switch is most likely to be the problem
Daewoo nubira veers to one side when accelerating?
I have a 2000 Daewoo Nubira and I had the control arm replaced and it fixed the problem.
Replaced battery and alternator on 97 mercury sable and it keeps stalling what is the problem?
Idle air control? Fuel pump? Coil?
Couple of questions have a 93 Chevy lumina anti lock brake light stays on what could be the problem car just recently stopped running had the ignition control module replaced still won't start?
just found out that it needed a fuel pump. engine was flooded and needed to dry up.
Mazda mpv 2000 VTCS Fault?
There is one issue for this fault. The manifold runner control actuator needs replaced and this will solve the problem.
2000 sl surging and idling high?
I have the same problem. I believe the idle air control valve either needs to be cleaned or replaced.
How to fix a clucth problem with a 240sx 1992 Nissan. just recently replaced the clucth leaving the old bearing on it is still having the clucth to slip what do i do?
you might have put the clutch in backward........
Why is 93 ford explorer 4x4 fwd portion not engaging on push buton four wheel drive?
Failure in the electric control motor is the most common problem.
Why did The right two gauges stoped working and the power to the ac go out on my 2000 Malibu?
I have a 2000 Malibu and I am having the same problem. There is an electrical problem. I have yet to figure out how to solve it, but turning on the AC blows the fuse. Ive had the instrument cluster replaced, so dont go and do that, because your car will still do the same thing. Your BCM (Body Control Module) may need to be replaced, or it is just a bad wiring. If you have replaced your battery, that may be a part of the problem. I know this information is not much, but hopefully it will help. I have a 2000 Malibu and I am having the same problem. There is an electrical problem. I have yet to figure out how to solve it, but turning on the AC blows the fuse. Ive had the instrument cluster replaced, so dont go and do that, because your car will still do the same thing. Your BCM (Body Control Module) may need to be replaced, or it is just a bad wiring. If you have replaced your battery, that may be a part of the problem. I know this information is not much, but hopefully it will help.
Where is the turn signal control relay located on a 1998 Chrysler Sebring Coupe?
I have a turn signal light that keeps flashing regardless of the control arm position. I think that the problem is in the turn signal control relay but I don't know where it is located. I did find the 3 prong relay located behind the center console but this is not the problem because I replaced it and have the same problem.
