0
What else can I help you with?
Where is the ignition control module for a 1995 ford windstar?
There is not a stand-alone ignition control module in the Windstars.Ignition control is fully handled by the Powertrain Control Moduel (PCM).See "Related Questions" below for more
What if your 86 bronco ll will not start evn though you have replaced the battery and ignition coil?
it could be the control module
What are control questions?
control questions.
Why would a 1989 Chevy Celebrity 2.8 crank go about 3 miles and then not crank again just turn over replaced the cranksensor relay switch but still nothing and replaced the fuses.?
Check the ignition control module.
Why does your 84 z die when accelerating Ignition coil has been replaced fuel pressure is good Is there a sensor doing this?
You have an ignition Control Module that you can check that controls ignition timing Throttle Position Sensor that tells the computer where the throttle is so it can regulate and give the correct air fuel ratio.
How do you change the Ignition Control Module in a 1995 Blazer S-10?
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
1986 grand marquis has power to the coil but no fire from the coil to the plugs the coil has been replaced and still nothing what else would be wrong?
Replace the ignition control module
Where is the ignition control module on a 1997 Sonata?
Regarding a model 1997,2 liter sonata, there is not an ignition control module as such. Ignition control comes from the ECM (ELECTRONIC CONTROL UNIT) through the Ignition Power Transistor (often called Igniter) and then to the Ignition coil.I do not have any information on the 1.8 or the 3.0 liter models.
Where is body control module on 2003 Cadillac CTS?
I'm not sure where it is located. But, I had mine replaced recently because of a problem of my gears not shifting (key stuck in ignition). I was told that the BCM is what control the signal when pressing down on brake to shift out of park. Also, my gas gauge doesn't work (reads Empty) and I can't check my oil/transmission level on my dash ( it reads XXX). I think I need a ECM.
Where is the location of the ignition control module on a Ford Focus?
You can find the Ford Focus ignition control module beneath the drivers side dashboard. The ignition control module will be above the accelerator pedal.
Is there a distributor - ignition control module on 1996 or newer Taurus - Sables?
AnswerSince 1996, engine ignition control has been handled by the Powertrain Control Module (PCM).The PCM has direct control over the ignition coils / coilpack (or coil-on-plug on some engines) - so the need for a 'distributor' has gone away.Coilpacks cost about $75Sidebar: without a distributor, the engine timing is also totally handled by the PCM.See "Related Questions" below for information about Ignition Control Modules on 1986-1995 Taurus/Sables.On a 1996 Ford Taurus the ignition control module is part of the drivetrain control module. To change the ignition control module you have to change out the computer. It is located behind the motor on the passenger side of the engine compartment. Look for a screw holding in a wiring plug with a dozen or so wires. The drivetrain control module has a couple of nuts holding it in place and looks like a cdrom when removed. Good luck. John
Where is the ignition control module in a 1997 mercury villager?
The ignition control module sit directly below the distributor.
