Heater Cores and Blower Fans

1999 Sebring Convertible heater frequently burns out a resistor in the resistor block how is the blower motor removed?

123

Top Answer
User Avatar
Wiki User
Answered
2010-12-09 02:45:31
2010-12-09 02:45:31

The blower motor is located in the same area as the resistor, it's held in with 3 screws. Removing them will allow the motor and wheel to drop down.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions



It is behind the rear seat back. The seat has to be removed to access.


The driver side front tire, and inner fender liner need removed.


The engine and transmission are removed together out the bottom.The engine and transmission are removed together out the bottom.


Shop vac. There are plugs in the rear wheel wells which need to be removed for the water to drain.


The engine is removed out of the bottom with the trans at the same time.



Down the middle of the valve covers. On a V6 the intake has to be removed to access the rear three.


The thermostat for a 2004 Sebring Convertable is in under the water outlet for the BOTTOM radiator hose. This is behind the alternator which will have to be removed, after you remove the belts. Plan on an afternoon of work. Hope this helps.


The shift solenoid B for a 1997 Chrysler Convertible is located inside the transmission. The speed sensor has to be removed to access the bolts to remove the cover over this shift solenoid.


Fuel Pump is located in gas tank as a part of the assembly includes sending unit, fuel filter and pump Tank has to be removed to access.


Didn't make a convertible in 1984. It has Targa roof panel that can be removed with a tool.


To remove a Boxster convertible top from a vehicle, there are several screws that have to be removed at the point where the top meets the trunk. The bots must also be removed from the hinges on the sides.


The heater core can be removed from a 2001 Chrysler Sebring by taking it off its mounting. This is done by removing the dash.


The most popular feature on a convertible car is that its roof can be removed, letting place for the highway winds and the sun. This is one of the many BMW convertible features.


The center counsel on a 2007 Chrysler Sebring can be removed by loosening the bolts on the bottom of the Council. The bolts are located at the back of the Council.


if we remove a resistor from the parallel connection the effective resistance value will be increased.


Changing the actual resistor is dead easy. The hard part is gaining access to the resistor. Some vehicles need the dash assembly removed to gain access.


I have a 2002 Chrysler Sebring convertible. If you turn off the ignition and remove the key while the headlights are on, then turn off the headlights, the headlights will stay on for 30 seconds and turn off. You can avoid this by turning the lights off before you turn off the car or by switching them on and off again.



The engine and transmission are both removed out the bottom.



In most cases located in the fuel tank that will have to be removed


The factory alarm is built into the body and engine computers and can not be removed.


under the driver side front fender the wheel must be removed for access.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.