Take a look under the hood at the top of the engine on the right side of the intake manufold. There is a vacuum line that connects to a rubber boot. that boot pops off at times or may be torn. Replace the rubber connector and everything should be fine...
What causes a hard rattling knocking sound under the hood when you start your 98 ford windstar? Lack of oil, lack of oil pressure, badly worn camshaft or crankshaft or a combination of all the above.
why does my ford expedition crank over but not start all the time
Try putting lubricant on the key or in the ignition or both. It worked for mine.
It is a big job. If you attempt it, get a manual from AUTOBOOKSONLINE.COM
My 1999 Mazda 626 is hard to start any time but then we kick start it then it start fine and dies at any robot will I'm driving My 1999 Mazda 626 is hard to start any time but then we kick start it then it start fine and dies at any robot will I'm driving
Yes they do have struts and they aren't hard to change
I can say with the highest confidence your temperature blend door actuator motor has failed. It is the #1 cause of heating problems on the Windstar line. Luckily it's not too hard of a fix, and not too expensive ($45). See "Related Questions" below for more details and lots of good tricks & tips on replacing the actuator.
on the top of the transmission it is very hard to get to i just got mine changed at a shop and i watched the guy change it.
Hard starting, loss of power, poor fuel economy, and a blowing noise under full acceleration.
when it is worm you got to keep the throttle down to start
There are several things that can cause your 1996 Ford Explorer to stall in start hard. The most common cause is a fuel pump that is going bad.
The 1999 Ford Ranger 3.0 liter water pump bolt torque specifications are 40 pounds. You do not want to torque the bolts to hard or they will break.