0
2000 Ford Escort ZX2 and Replaced the Crankshaft Sensor only to drive about 10 mile and it go out again What causes what looks like wear down?
Wiki User
∙ 15y ago
you have to gap the crank sensor when u install it, the sensor should have a paper in the box that tells u what to gap it at. you will need brass feeler gauges because the sensor is magnetic
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What causes a crankshaft sensor to go bad?
Thermocycling.
2003 dodge durango runs rough what are some of the causes?
Try checking for the crankshaft sensor
What causes a faulty pulse signal on a 89 ford probe?
Pulse signals from what? speed sensor abs wheel sensor fuel pump pressure sensor crankshaft sensor camshaft sensor knock sensor
What causes 98 ford escort zx2 temperature gauge to be inoperative?
The temperature sensor is probably bad
What causes a crankshaft position sensor to go bad on 96 eclipse?
If you have a 4g63 motor a common problem is crankwalk, this will damage or break off the sensor.
What causes the speedometer to be intermittent on a 1997 Ford Taurus and how is it fixed?
Have the speed sensor replaced.
What causes a 98 Firebird to skip really bad and sometimes stall Replaced crankshaft sensor plugs wires ignition module Still having problems What else could it be?
look at the fly wheel to see if it has any missing teeth that might be the problem
Would a harmonic balance cause a crankshaft position sensor to go bad for a 2004 KIA optima?
I don't think so since its purpose is to balance and cancel vibration. It is mounted on the opposite end of the engine. Usually the crankshaft sensor fails because of oil contaminating on the sensor. Difference in temperature with the oil causes the sensor to malfunction intermittently.
How do you fix a Chrysler PT Cruiser with a P0016 code?
Possible causes could be,Timing gear misaligned,Faulty crankshaft position sensor,Faulty camshaft position sensor,Engine oil dirty,Incorrect engine oil viscosity,Crankshaft position sensor circuit is open or shorted,Camshaft position sensor circuit is open or shorted,
What causes an O2 heater circuit malfunction on a IS 300?
The oxygen sensor is "done". It should be replaced.
What causes a hall effect crankshaft sensor to fail?
heat, primarily. either causing degausing of the permanant magnet behind the sensor, or other thermal damage to the hall ic itself.
What causes a 99 Alero to stall on ignition when the engine is warm?
The crank sensor probably needs to be replaced.
